Abstract:We characterize a novel instrument designed for radiation field decomposition and particle trajectory reconstruction for application in harsh radiation environments. The device consists of two Timepix3 assemblies with 500 μm thick silicon sensors in a face-to-face geometry. These detectors are interleaved with a set of neutron converters: 6 LiF for thermal neutrons, polyethylene (PE) for fast neutrons above 1 MeV, and PE with an additional aluminum recoil proton filter for neutrons above ∼4 MeV. Application of the coincidence and anticoincidence technique together with pattern recognition allows improved separation of charged and neutral particles, their discrimination against γ-rays and assessment of the overall directionality of the fast neutron field. The instrument's charged particle tracking and separation capabilities were studied at the Danish Center for Particle Therapy (DCPT), the Proton Synchrotron, and Super Proton Synchrotron with protons (50–240 MeV), pions (1–10 GeV/c and 180 GeV/c). After developing temporal and spatial coincidence assignment methodology, we determine the relative amount of coincident detections as a function of the impact angle, present the device's impact angle resolving power (both in coincidence and anticoicidence channels). The detector response to neutrons was studied at the Czech Metrology Institute (CMI), at n_ToF and the Los Alamos Neutron Science Center (LANSCE), covering the entire spectrum from thermal up to 600 MeV. The measured tracks were assigned to their corresponding neutron energy by application of the time of flight technique. We present the achieved neutron detection efficiency as a function of neutron kinetic energy and demonstrate how the ratio of events found below the different converters can be used to assess the hardness of the neutron spectrum. As an application, we determine the neutron content within a PMMA phantom just behind the Bragg-peak during clinical irradiation condition with protons of 160 MeV.

A prototype 4D-tracking demonstrator based on the TimeSPOT developments

4-Dimensional Tracking with Ultra-Fast Silicon Detectors

Demonstration of particle tracking with scintillating fibres read out by a SPAD array sensor and application as a neutrino active target

4D-tracking with digital SiPMs

Characterisation of a customised 4-chip Timepix3 module for charged-particle tracking

High performance picosecond- and micron-level 4D particle tracking with 100% fill-factor Resistive AC-Coupled Silicon Detectors (RSD)

The FE-I4 Telescope for particle tracking in testbeam experiments

STOPGAP -- a Time-of-Flight Extension for the Belle II TOP Barrel PID System as a Demonstrator for CMOS Fast Timing Sensors

The Cbm Time-Of-Flight Wall - A Conceptual Design

From 3D to 5D tracking: SMX ASIC-based Double-Sided Micro-Strip detectors for comprehensive space, time, and energy measurements

High-Precision 4D Tracking with Large Pixels using Thin Resistive Silicon Detectors

A two-layer Timepix3 stack for improved charged particle tracking and radiation field decomposition

Mighty Tracker -- Performance Studies of the MightyPix for LHCb

Development and Test of a Μtpc Cluster Reconstruction for a Triple GEM Detector in Strong Magnetic Field

Erratum: Development of Time Projection Chamber prototype integrated with UV laser tracks for the future circular e<sup>+</sup>e<sup>-</sup> collider

OptoTracker project proposal

Timing resolution of a LAPPD prototype measured with CERN PS test beams

Characterization of LAPPD timing at CERN PS testbeam

Beyond the CMOS sensors: the DoTPiX pixel concept and technology for the International Linear Collider A

A Time Projection Chamber with GEM-based Readout