Abstract:The production of hydrogen via photoelectrochemical (PEC) water splitting using III-V semiconductors as photoelectrodes is a field of current research and challenges in materials science. Under PEC conditions relevant to water splitting, III-V semiconductors are prone to corrosion and suffer from corrosion-related decrease of efficiency, which so far impedes long-term usage of III-V semiconductor-based photoelectrodes. Gallium phosphide (GaP) has an indirect band gap of 2.26 eV which covers both the hydrogen evolution potential (HEP) and the oxygen evolution potential (OEP). Thus, in principal, GaP can be used both as photocathode and photoanode. Notwithstanding the favorable band gap energy, the use of GaP photoelectrodes for the photolysis of water has so far not been successful without applying an additional bias potential. In this contribution we demonstrate that, by specific surface conditioning, we are able to control and optimize the photoelectrochemical surface properties of photoanodes prepared from n-doped GaP(100) for PEC water splitting. We have studied the structural and chemical surface modifications of such photoanodes before and after extended PEC processes by scanning electron microscopy (SEM), atomic force microscopy (AFM), Auger electron spectroscopy (AES) and X-ray photoelectron spectroscopy (XPS). An approximately (2±1) nm thin oxide film is produced at the surface of n-GaP(100) via oxidizing the surface at 0.8 V vs RHE (reversible hydrogen electrode) and subsequent hydrogen evolution at very cathodic potentials. The latter step is crucial for a substantial reduction of the potential for water splitting, presumably because the evolved hydrogen passivates electrically active defects in the oxide film. After appropriate surface conditioning, photolytic water splitting was observed without applied voltage or addition of catalysts, as confirmed by detection of hydrogen gas evolving at the Pt counter cathode with a gas spectrometer. The n-GaP(100) photoanode was exposed to high-intensity illumination (120 mW/cm 2 ) at 0 V vs RHE in 0.02 M HCl electrolyte for a duration of 3 days while yielding stable photocurrents. Ex-situ surface characterization of the n-GaP(100) photoanodes was carried out after extended PEC water splitting. AFM revealed a very flat surface, and no signs of corrosion were observed even after extended periods of water splitting. AES depth profiles showed that phosphorous was depleted near the surface of the n-GaP(100) photoanode. Using AES spectra, the thickness of the oxide film was estimated. XPS measurements revealed that the surface oxide consists mainly of Ga 2 O 3 , while small concentrations of GaPO 4 , P 2 O 5 and also metal-like Ga are also present at the topmost surface layers of the n-GaP(100) photoanode. Electrochemical impedance spectroscopy (EIS) was carried out to understand the charge transfer processes across the semiconductor/electrolyte interface. Our EIS results suggest that defect states in the surface oxide and metal-like Ga at the very surface in contact with the electrolyte play crucial roles in the effective charge transfer across the semiconductor-electrolyte interface. Our surface conditioning processes lead to the formation of a nonporous, thin and stable Ga surface oxide which inhibits PEC surface corrosion and, at the same time, subserves the water splitting process.

Water adsorption on the P-rich GaP(100) surface: Optical spectroscopy from first principles

The interface of GaP(100) and H2O studied by photoemission and reflection anisotropy spectroscopy

Adsorption and desorption of hydrogen at nonpolar GaN(1-100) surfaces: Kinetics and impact on surface vibrational and electronic properties

DFT Simulations of Water Adsorption and Activation on Low-Index Α-Ga2o3 Surfaces.

Surface Adsorption Properties of GaP (bar 1bar 1bar 1) Studied by XPS, UPS and HREELS

Water Adsorption on the Be(0001) Surface: from Monomer to Trimer Adsorption

On the physisorption of water on graphene: Sub-chemical accuracy from many-body electronic structure methods

Comparative high-resolution electron-energy-loss spectroscopy study of hydrogen adsorption on GaAs and InP (111) and (1¯ 1¯ 1¯) surfaces

Oxidation State of GaP Photoelectrode Surfaces under Electrochemical Conditions for Photocatalytic CO2 Reduction

Structures and Mechanisms of Water Adsorption on ZnO(0001) and GaN(0001) Surface

Insitu Electron-Spectroscopy Studies Of Interaction Between P And Gaas(100) Surface

Influence of Excess Charge on Water Adsorption on the BiVO4(010) Surface

Binding Sites of Water Molecules on Gan (100) Surface: Dft Calculations

Photolytic Water Splitting By Surface-Conditioned n-Gallium Phosphide(100) Photoanodes

Wettability and "petal effect" of GaAs native oxides

Surface reaction of sodium on InP(111) and its role on enhancement of water vapor adsorption

High reactivity of H2O vapor on GaN surfaces

Structure and interactions at the Mg(0001)/water interface: An ab initio study

The Interfacial Structure of InP(100) in Contact with HCl and H$_2$SO$_4$ studied by Reflection Anisotropy Spectroscopy

Hydroxyl Group Adsorption on GaN (0001) Surface: First Principles and XPS Studies

General aspects of the vapor growth of semiconductor crystals - a study based on DFT simulations of the NH3/NH2 covered GaN(0001) surface in hydrogen ambient