Erasing and Correction of Liquid Metal Printed Electronics Made of Gallium Alloy Ink from the Substrate

Rongchao Ma,Yixin Zhou,Jing Liu

DOI: https://doi.org/10.48550/arXiv.1706.01457

2017-06-05

Abstract:Gallium-based liquid metals have recently been found important in a variety of newly emerging applications such as room temperature metal 3D printing, direct writing of electronics and biomedicine etc. In all these practices, one frequently encounters the situations that a printed circuit or track needs to be corrected or the unwanted parts of the device should be removed as desired. However, few appropriate strategies are currently available to tackle such important issues at this stage. Here we have identified several low cost ways toward this goal by comparatively investigating three typical strategies spanning from mechanical, chemical, to electrochemical principles, for removing the gallium-based liquid metal circuits or thin films. Regarding the mechanical approach, we constructed an eraser for removing the liquid metal thin films. It was shown that ethanol (CH3CH2OH) could serve as a good candidacy material for the mechanical eraser. In the chemical category, we adopted alkalis and acids to remove the finely printed liquid metal circuits and sodium hydroxide (NaOH) solution was particularly revealed to be rather efficient in making a chemical eraser. In the electrochemical strategy, we applied a 15 V voltage to a liquid metal thin film (covered with water) and successfully removed the target metal part. These methods were comparatively evaluated with each of the merits and shortcomings preliminarily clarified in the end. The present work is expected to be important for the increasing applications of the liquid metal enabled additive manufactures.

Applied Physics