Abstract:Using wood biomass as opposed to petroleum/fossil feedstock to synthesize chemicals and monomers offers the value proposition of a reduced carbon foot print. A critical step in biomass utilization is to obtain the fermentable monomeric pentose and hexose sugar subunits from various lig-nocellulosic polymers. However, lignin is a three-dimensional amorphous polymer based on methoxylated phenylpropanoid units, and is crosslinks to different polysaccharides with covalent bond. The presence of lignin is a barrier to enzymatic hydrosis of cellulose by cellulases, as well as inhibiting fermentation to form products such as ethanol. Usually, there are three approaches to fractionate biomass into useful chemicals. The first one is extract lignin at high temperature and pressure. The second approach involves more severe conditions such as the temperatures and pressures used in gasification, or use the mineral acids at elevated temperatures to liberate sugars for fermentation. The third way is dissolution of biomass using ionic liquid to extract lignin, and then re-precipitation the cellulosic residue. In this paper, we investigate the lignin extraction uses a purpose designed ionic liquid (IL) 1 -butyl-3-methylimidazolium acesulfamate [BMIM]Ace at room temperature and open atmosphere. It was synthesized from the sugar acesulfamate potassium (Ace K), and with good property of greater thermal stability, increased viscosities, and inability to dissolve crystalline cellulose. In addition, it is of low cost and nontoxic, and is expected to interact with lignin owing to its aromatic character of anion. Organic solvents were firstly used in the extraction process, which reduce the viscosity of IL and increase the lignin yield. The lignin can be obtained by using acetone as the reconstitution solvent (IL/acetone 1:3, v/v), and approximately 11.5% and 96.5% of lignin and the reconstitution cellulose-rich material have been achieved in one dissolution/reconstitution cycle by fresh IL, respectively. It was found that the presence of some organic solvents mix with IL can increase the extraction efficiency. The regenerated ionic liquid showed good retention of structure and properties. The regenerated lignin fractions exhibited large molecular weights (M-w, 3700-7810 g mol(-1)). The physicochemical properties of the extracted lignin fractions were characterized by Fourier transform infrared (FT-IR), and high-performance anion exchange chromatography (HPAEC). The reconstitution cellulose-rich material can be serving as a valuable source for enzymatic saccharification for next step. These results indicate a potential approach in further optimization of the choice of low-cost Its combined with organic solvents for the efficient utilization of the wood biomass.

Preparation of magnetic silica supported Brønsted acidic ionic liquids for the depolymerization of lignin to aromatic monomers

Solvothermal Liquefaction of Alkali Lignin to Obtain a High Yield of Aromatic Monomers While Suppressing Solvent Consumption

The ionic liquids upon perchlorate to promote the C-C/C-O bonds cleavage in alkali lignin under photothermal synergism

Theoretical Elucidation of β-O-4 Bond Cleavage of Lignin Model Compound Promoted by Sulfonic Acid-Functionalized Ionic Liquid

Synergy of Single Atoms and Lewis Acid Sites for Efficient and Selective Lignin Disassembly into Monolignol Derivatives.

Acidic Ionic Liquid as Both Solvent and Catalyst for Fast Chemical Esterification of Industrial Lignins: Performances and Regioselectivity

First evaluation of multifunctional poly(ionic liquid)s as novel strong bases in directional efficient valorization of lignin

[C4h8so3hmim]hso4 As an Efficient Catalyst for Direct Liquefaction of Bagasse Lignin: Decomposition Properties of the Inner Structural Units

Esterification of lignin to produce pharmaceutical intermediates using mSiO2@Al mesoporous molecular sieve spheres as a catalyst

Optimizing lignin demethylation using a novel proton- based ionic liquid: 1, 2-propanediamine/glycolic acid catalyst

Efficient Lignin Depolymerization Process for Phenolic Products with Lignin-Based Catalysts and Mixed Solvents

Depolymerization of Native Lignin over Thiol Capped Ultrathin ZnIn2S4 Microbelts Mediated by Photogenerated Thiyl Radical

Depolymerization of Methylene Linkage in Condensed Lignin with Commercial Zeolite in Water

Depolymerization of Lignosulfonate Catalyzed by Different Solid Base Oxides to Prepare Phenolic Compounds

FeCl3-Promoted Photocatalytic Cleavage of Cα-Cβ Bond in Lignin and Lignin Model to Benzoic Acid.

Mechanism Studies in Electrochemical Depolymerization Processes of Alkali and Organosolv Lignin

Mild Redox-Neutral Depolymerization of Lignin with a Binuclear Rh Complex in Water

Ionic liquids screening for lignin dissolution: COSMO-RS simulations and experimental characterization

Synthesis of Magnetic Lignin-Based Hollow Microspheres: A Highly Adsorptive and Reusable Adsorbent Derived from Renewable Resources

Extraction Of Lignin From Wood Biomass Using A New Ionic Liquid At Open Atmosphere

Superparamagnetic composites of lignin regenerated from ionic liquid solutions for the efficient and selective removal of cationic dyes