Abstract:The topologically protected edge states of elastic waves in phononic crystal plates have the outstanding characteristics in wave manipulation such as the strong suppression of back-scattering and defect immunity, which can be used for controlling vibration and noise, detecting the structural damage, conducting the material nondestructive test and other engineering practices, and therefore have received much attention. But for plate structures, the propagation of elastic waves is complicated due to the coexistence and coupling of different types of wave modes, resulting in a challenge in designing topologically protected states. In this paper, a simple phononic crystal plate with triangular holes is designed for elastic wave manipulation based on topologically protected edge states. The band structure characteristics of the unit cell are studied by varying the rotation angle θ of the triangular holes around their geometric centers from the initial positions. It is found that the band structure of the initial unit cell with rotation angle θ = 0° has two pairs of degenerate modes. At \begin{document}$ \theta = \pm 33^\circ $\end{document}, a double Dirac cone appears at the center Γ point of the Brillouin zone without requiring the lattices to fold, and a band inversion occurs on both sides of \begin{document}$ \pm 33^\circ $\end{document} which can be characterized as a topological phase transition. The elastic band gap and two kinds of pseudospin states with clockwise or counterclockwise circulating mechanical energy flux patterns in the band structure are found by calculating the projected band structures of a supercell which is composed of phononic crystals with different topological phases. Based on this finding, different constructions of phononic waveguide are used for implementing the numerical analysis to demonstrate the back-scattering immunity of the edge states when disorder, tortuosity and cavity are introduced into the waveguide. Unidirectional robust propagation and multichannel waveguide switch due to the pseudospin-dependent one-way edge modes are also validated with numerical models. The phononic crystal plate presented in this paper provides a simple realizable method of designing the topologically protected elastic edge states.

Edge waves in plates with resonators: An elastic analogue of the quantum valley Hall effect

Coexistence of Pseudospin- and Valley-Hall-like Edge States in a Photonic Crystal with C3v Symmetry

Experimental demonstration of topological waveguiding in elastic plates with local resonators

Valley transport via dual-band elastic topological edge states in local-resonant phononic crystal plate

Dirac Degeneracy and Elastic Topological Valley Modes Induced by Local Resonant States

Valley based splitting of topologically protected helical waves in elastic plates

Polarized Elastic Topological States in Hexagonal Lattices

Edge states and the valley Hall effect

Topologically Protected Edge States of Elastic Waves in Phononic Crystal Plates

Observation of topologically protected helical edge modes in Kagome elastic plates

Topological Edge States for Flexural Waves in Perforated Phononic Plates

Simultaneous pseudospin and valley topological edge states of elastic waves in phononic crystals made of distorted Kekulé lattices

Topological valley-chiral edge states of Lamb waves in elastic thin plates

Pseudospins And Topological Edge States In Elastic Shear Waves

High-frequency Topological Corner and Edge States in Elastic Honeycomb Plates

Topological spin-Hall edge states of flexural wave in perforated metamaterial plates

Routing Edge States in an Anisotropic Elastic Topological Insulator

Sub-wavelength topological boundary states and rainbow trapping of local-resonance phononic crystal plate

Valley-Chiral Edge States of Antisymmetric Plate Wave in Phononic Crystals with Linear Defect

Edge states and corner modes in second-order topological phononic crystal plates

Hermitian and Non-Hermitian Topological Edge States in One-Dimensional Perturbative Elastic Metamaterials