A Simple Analytical Model of Coupled Single Flow Channel over Porous Electrode in Vanadium Redox Flow Battery with Serpentine Flow Channel

Xinyou Ke,J. Iwan D. Alexander,Joseph M. Prahl,Robert F. Savinell
DOI: https://doi.org/10.1016/j.jpowsour.2015.04.138
2016-10-17
Abstract:A simple analytical model of a layered system comprised of a single passage of a serpentine flow channel and a parallel underlying porous electrode (or porous layer) is proposed. This analytical model is derived from Navier-Stokes motion in the flow channel and Darcy-Brinkman model in the porous layer. The continuities of flow velocity and normal stress are applied at the interface between the flow channel and the porous layer. The effects of the inlet volumetric flow rate, thickness of the flow channel and thickness of a typical carbon fiber paper porous layer on the volumetric flow rate within this porous layer are studied. The maximum current density based on the electrolyte volumetric flow rate is predicted, and found to be consistent with reported numerical simulation. It is found that, for a mean inlet flow velocity of 33.3 cm s-1, the analytical maximum current density is estimated to be 377 mA cm-2, which compares favorably with experimental result reported by others of ~400 mA cm-2.
Fluid Dynamics
What problem does this paper attempt to address?
The problem that this paper attempts to solve is in the Vanadium Redox Flow Battery (VRFB). By establishing a simple analytical model, it aims to understand the hydrodynamic behavior in the coupled system of serpentine flow channels and porous electrodes, especially how the fluid enters the porous electrode from the serpentine flow channel and the impact of this flow on battery performance. Specifically, this research focuses on the following aspects: 1. **Hydrodynamic Modeling**: An analytical model was developed to describe the fluid flow in a layered system consisting of a single serpentine flow channel and a parallel underlying porous electrode. This model is based on the Navier - Stokes equation in the flow channel and the Darcy - Brinkman model in the porous layer, and the continuity conditions of flow velocity and normal stress are applied at the interface between the flow channel and the porous layer. 2. **Analysis of Parameter Influence**: The influence of inlet volumetric flow rate, flow channel thickness, and typical carbon fiber paper porous layer thickness on the volumetric flow rate within the porous layer was studied. Through these analyses, a better understanding of the influence of different design parameters on battery performance can be achieved. 3. **Prediction of Maximum Current Density**: Based on the electrolyte volumetric flow rate, the maximum current density was predicted and found to be consistent with the reported numerical simulation results. For example, for an average inlet flow velocity of 33.3 cm/s, the maximum current density predicted by the analytical model is 377 mA/cm², which is very close to the experimental result of approximately 400 mA/cm². Through these studies, the author aims to provide theoretical support for the design and optimization of flow battery performance, especially in terms of improving battery power density and efficiency.