Abstract:Abstract This paper presents 3D Fabry–Pérot (FP) cavities fabricated directly onto cleaved ends of low-loss optical fibers by a two-photon polymerization (2PP) process. This fabrication technique is quick, simple, and inexpensive compared to planar microfabrication processes, which enables rapid prototyping and the ability to adapt to new requirements. These devices also utilize true 3D design freedom, facilitating the realization of microscale optical elements with challenging geometries. Three different device types were fabricated and evaluated: an unreleased single-cavity device, a released dual-cavity device, and a released hemispherical mirror dual-cavity device. Each iteration improved the quality of the FP cavity’s reflection spectrum. The unreleased device demonstrated an extinction ratio around 1.90, the released device achieved 61, and the hemispherical device achieved 253, providing a strong signal to observe changes in the free spectral range of the device’s reflection response. The reflectance of the photopolymer was also estimated to be between 0.2 and 0.3 over the spectrum of interest. The dual-cavity devices include both an open cavity, which can interact with an interstitial medium, and a second solid cavity, which provides a static reference reflection. The hemispherical dual-cavity device further improves the quality of the reflection signal with a more consistent resonance, and reduced sensitivity to misalignment. These advanced features, which are very challenging to realize with traditional planar microfabrication techniques, are fabricated in a single patterning step. The usability of these FP cavities as thermal radiation sensors with excellent linear response and sensitivity over a broad range of temperature is reported. The 3D structuring capability the 2PP process has enabled the creation of a suspended FP heat sensor that exhibited linear response over the temperature range of 20 oC –120 oC; temperature sensitivity of ∼50 pm oC −1 at around 1550 nm wavelength; and sensitivity improvement of better than 9x of the solidly-mounted sensors.

Air-structured optical fibre drawn from a 3D-printed preform

3D freeform printing of silk fibroin

Technique for Fabricating Complex Structured Fibers by Rolling of Glass Preforms

Ultra-simplified Single-Step Fabrication of Microstructured Optical Fiber

Harnessing Deep-Hole Drilling to Fabricate Air-Structured Polymer Optical Fibres

Three-dimensional Fabry–Pérot cavities sculpted on fiber tips using a multiphoton polymerization process

Metafiber transforming arbitrarily structured light

Mid-infrared hollow core fiber drawn from a 3D printed chalcogenide glass preform

Optical Fabrication of Three-Dimensional Polymeric Microstructures

4D Optical fibers based on shape-memory polymers

Optical Fiber-Assisted Printing: A Platform Technology for Straightforward Photopolymer Resins Patterning and Freeform 3D Printing

Three-dimensional microfabrication through a multimode optical fiber

Nanoimprint of a 3D structure on an optical fiber for light wavefront manipulation

3D Printing of Glass Micro-Optics with Subwavelength Features on Optical Fiber Tips

Extrusion-based 3D co-printing: printing material design and novel workflow for fabricating patterned heterogeneous tissue structures

Fabrication of optical components with nm- to mm-scale critical features using three-dimensional direct laser writing

3D printing of optical materials: an investigation of the microscopic properties

The future of short-range high-speed data transmission: printed polymer optical waveguides (POW) innovation, fabrication, and challenges

Ultrafast Laser 3D Nanolithography of Fiber-Integrated Silica Microdevices

Multimaterial preform coextrusion for robust chalcogenide optical fibers and tapers

Mid-IR Hollow-core microstructured fiber drawn from a 3D printed PETG preform