Abstract:This paper describes the process of conceptualization, design, and testing of the Onboard Computer (OBC) Software for a 3U nanosatellite. The on-board computer of the satellite is responsible for initiating dataflow between onboard hardware, performing image compression, and run control algorithms like fine pointing, sun pointing, ground pointing for payload operation and idle state detumbling. The actuation is carried out by interfacing magnetorquers and reaction wheels with the OBC. The software of the onboard computer is implemented on a Linux based operating system run on the ARM Cortex A9 processor which is part of the Zynq-7000 SoC. A Field Programmable Gate Array (FPGA) is used specifically for image compression. The compressed image is stored in a serial flash memory shared between the camera and the FPGA. The architecture comprises of a system-wide I2C bus to which the sensors interfaced. The collected data is used for logging followed by downlink and as input to algorithms used for pointing and detumbling. An SPI interface is used between the Power Subsystem microcontroller and the On-Board Computer since a large amount of housekeeping data will have to be exchanged at high rates. Reaction wheels and magnetorquers are actuated by current driver circuits which get the control signals from the OBC. The satellite is modelled as a Finite State Machine for software development. The states broadly fall under two categories, Normal and Emergency. Each state has a predetermined set of logical tasks to be run, which are abstracted as separate processes in the memory. State transitions take place by polling the health metrics of the satellite. However, hardware interrupts are implemented on selected peripherals which ensure an asynchronous switching to the Emergency States for safety. A review of some common fault detection, isolation and removal methods used shall conclude the paper.

On Board Data Handling (OBDH) based on PC104

Design And Construction Of A Satellite Data Processing System (Satdps) For Marine Application

Logical Architecture Design of Integrated Electronic System with High Real-Time and Reliability in ZDPS-2 Pico-Satellite

Design and implementation of the highly-reliable, low-cost housekeeping system in the ZDPS-1A pico-satellite

Fault-Tolerant Design of Memory Module for Pica-satellite On-Board Computer

Design of radiation-hardened real-time operating system for pico-satellites

Development of On Board Computer for a Nanosatellite

Data Bus of On-Board Data System for Micro-Small Satellite

The design of an adaptive on-board computer for small satellites

Design and Implementation of a Low-Cost Fault-Tolerant On-Board Computer for Micro-Satellite

Research on key technologies of on-board computer design with commercial off-the-shelf devices

Integrated Platform of On-Board Computer and Star Sensor Electronics System Based on COTS

Implementation of integrated OBD-II connector with external network

Design and Implementation of Intelligent Spaceborne Test Unit

Distributed Hardware-In-The-Loop Simulation for Space Robot on Can Bus

Design of an Object-Based Storage Device Based on I/O Processor

Research and Development of On-board Module Based on Automobile Remote Diagnostic System

A Scalable Tabletop Satellite Automation Testbed:Design And Experiments

Run-Time Control Design Of Micro-Satellite Obc Based On Reconfigurable Architecture

Problems of micro-satellite gbc and solving method based on reconfiguration technique

Development of Vehicle on Board Data Acquisition System Based on Embeded PC