Abstract:Traditional control systems transfer analog and digital signals to the power amplifier or other components via the computer,however they are bulky,and their structure is complex,the failure rate is high and these failures are difficult to be located.In order to achieve the real-time control for the simulator of five degrees of freedom (five-axis) coarse sun sensor physical signal source and simplify the system structure,the novel distributed real-time control system based on CAN fieldbus and using CanOpen protocol is researched.In this system,all the controls are distributed into computer,the fieldbus controller,servo drivers,digital I/O,and sensors,etc.,and the real-time data communication among all the components are connected via a network cable in cascade manmer;the failure of any node can be fast and accurately located and does not affect the normal operation of other nodes.The modular control system simplifies the design of the control system,reduces the number of cables and the space of the control system,minimizes the influence of the failures,and improves reliability and maintainability of the system.The flexibility and real-time performance of the system in motion trajectory are further verified by adopting the sinusoidal swing motion implemented by PVT.The control system promotes the development of the control structure in the industrial automation field,including stnucture simplification,real-time control performance and reliability,etc.

Distributed Hardware-In-The-Loop Simulation for Space Robot on Can Bus

High Fidelity Distributed Hardware-in-the-Loop Simulation for Space Robot on CAN-based Network

Design and Test of Hardware-in-the-loop Platform for Vehicle Chassis CAN System with Intermittent Open and Short Connection Faults

Open Architecture Multi-Axis Motion Control System for Industrial Robot Based on Can Bus

Research on Hardware-in-the-loop Simulation of Space Robot

A Robotic Hardware-in-the-Loop Simulation System for Flying Objects Contact in Space.

A HIL Simulation Facility for Task Verification of the Chinese Space Station Manipulator

Design and Demonstration for an Air-bearing-based Space Robot Testbed

The Development of Hardware-in-the-loop Simulation System of Hybrid Vehicle

Design of Hardware-In-Loop Simulation System for Unmanned Aerial Vehicle

Distributed Control System Design for Humanoid Robots

Distributed Real-Time Control System Used for Five-Axis Simulator

A Passivity-Based Velocity Control Method of Hardware-in-the-Loop Simulation for Space Robotic Operations

Hardware-in-the-Loop Simulation for Evaluating Communication Impacts on the Wireless-Network-Controlled Robots

Hardware-in-the-loop Simulation of Space Docking Device Using 6-DOF Parallel Robot

Design And Implementation Of The Universal Servo Control Algorithm Verification System Based On High-Speed Communication Fieldbus

Design and Experimental Study of Space Manipulator Simulator System

Ground simulation experiment verification of space robot with ADAMS and Simulink co-simulation

Hardware-in-the-loop simulation for the contact dynamic process of flying objects in space

Design and Implementation of a 6-DOF Robot Control System Based on CAN Fieldbus

Design, implementation and verification of hardware-in-the-loop control system for work-class ROVs