Abstract:In order to offer higher average brightness and more stable photon beam, top-up injection mode is scheduled for daily operation in SSRF. Several critical beam parameters, such as filling pattern, average current, beam lifetime and transfer efficiency, need to be measured precisely and reliably, and few interlock logics need to be added into machine protection system with top-up mode. Several hardware and software optimizations of beam instrumentation for this purpose will be introduced in this paper. OVERVIEW Shanghai Synchrotron Radiation Facility (SSRF) is a third generation light source, which located at Shanghai, P.R. China. Since December 2012, SSRF has operated in top-up mode for user experiments, which was a milestone of SSRF in facility performance improvements. The topup injections are made continuously at the time interval of about 10 minutes. Each injection cycle takes about 10 seconds and the bunch change uniformity of the 500 bunch train is better than 95%. For the top-up operation, several beam parameters, such as filling pattern, average current, beam lifetime and transfer efficiency, need to be measured precisely. Some extra interlock logics were added into machine protection system. This paper will introduce the details of hardware and software optimizations of beam instrumentation for the purpose above. FILLING PATTERN Bunch charge uniformity control is very important for the top-up operation. The quality mainly depends on the precision of bunch charge & filling pattern measurement. This measurement can be realized by direct sampling BPM pickup signal [1-3] or synchrotron radiation signal [4]. Due to easy configuration and good linearity button, BPM pickups and PXI waveform digitizer based solution have been adopted [5].

Using a double-frequency RF system to facilitate on-axis beam accumulation in a storage ring

A method of bunch by bunch measurement at nanoseconds interval by using cavity beam position monitors

Digital Bunch-By-Bunch Transverse Feedback System at Ssrf

Beam Instrumentation System Optimization for Top-up Operation in SSRF

Injection method of barrier bucket supported by off-aligned electron cooling for CRing of HIAF

Emittance-dominated Long Bunches in Dual Harmonic RF System

Realizing long radio-frequency quadrupole accelerators with multiple shorter and independent cavities

A Multi-Length Bunch Design for Electron Storage Rings with Odd Buckets

Study and Design of the Axial Injection System at SFC

A Double-Frequency Rf Gun for Field Emission

Microbunching enhancement by adiabatic trapping

Collective Effects for Long Bunches in Dual Harmonic RF Systems

Bunch-by-Bunch Study of the Transient State of Injection at the SSRF

Study of RF System of Hefei Storage Ring under Injection

Matched phase sweep method for the optimization of bunching factor in dual rf systems of high-intensity hadron synchrotrons

Methods for enhancing the steady-state microbunching in storage rings

Experimental Investigation of Transverse Quadrupolar Beam Oscillation in the Hefei Light Source-II Storage Ring

Study of injection scheme using pulsed quadrupole for HLS storage ring

Funneling with the Two-Beam RFQ

Bunch-by-bunch Beam Size Measurement During Injection at Shanghai Synchrotron Radiation Facility

Design approach for modern high-current, radio-frequency quadrupole accelerators with low emittance transfer