Auto-Ignition and Flame Characteristics of Ammonia Reactivity-Controlled Compression Ignition Combustion in Comparison with Methane

Lin Chen,Ren Zhang,Haiqiao Wei
DOI: https://doi.org/10.1021/acs.energyfuels.3c02236
IF: 4.6541
2023-08-04
Energy & Fuels
Abstract:Ammonia (NH3), as a hydrogen carrier, is the key to being carbon-neutral for internal combustion engines. However, the poor combustion properties of NH3 hindered the development of NH3 engines. In the current study, an optical engine is adopted and the auto-ignition and flame characteristics of NH3 reactivity-controlled compression ignition (RCCI) combustion (in comparison to CH4) are optically studied. The experimental results show that there exists a critical injection timing for the effect of pilot fuel on NH3 combustion. Before the critical timing, the combustion phase (auto-ignition) will delay because of the less over-rich pilot fuel. In addition, low-temperature heat release is observed for NH3/n-heptane under early injection timing conditions. When comparing the two fuels, the auto-ignition timing is delayed while the combustion duration (CA05-90) is shorter for NH3 combustion. The main reason is that the low chemical reactivity of NH3 inhibits the auto-ignition of the pilot fuel (n-heptane), while the next oxidation pathways of NH3 are extremely fast. Flame images show that, for NH3 RCCI combustion, the highest probability of auto-ignition is in the bottom and NH3 flame nearly propagates from the edge to the center, which is mainly due to the temperature inhomogeneity of the cylinder. Meanwhile, for CH4 combustion, the highest probability of auto-ignition is in the center of the cylinder, and CH4 flame nearly propagates from the center to the edge. The current study revealed the similarities/differences between NH3 and CH4 under RCCI conditions and can give some insights into the application of NH3 engines.
energy & fuels,engineering, chemical
What problem does this paper attempt to address?