Abstract:This paper presents a novel interleaved soft-switching bidirectional snubberless current-fed full-bridge voltage doubler (dc/dc converter) for an energy storage system in fuel cell electric vehicles. A novel secondary modulation technique is also proposed to clamp the voltage across the primary-side switches naturally with zero-current commutation. It, therefore, eliminates the necessity for an external active-clamped circuit or passive snubbers to absorb the switch turn-off voltage spike, a major challenge in current-fed converters. Zero-current switching of primary-side devices and zero-voltage switching of secondary-side devices are achieved, which significantly reduce switching losses. An interleaved design is adopted over a single cell to increase the power handling capacity obtaining merits of lower input current ripple, reduction of passive components' size, reduced device voltage and current ratings, reduced conduction losses due to current sharing, and better thermal distribution. Primary device voltage is clamped at rather low-reflected output voltage, which enables the use of low-voltage semiconductor devices having low on-state resistance. Considering input current is shared between interleaved cells, conduction loss of the primary side, a considerable part of total loss, is significantly reduced and higher efficiency can be achieved to obtain a compact and higher power density system. Steady-state operation, analysis, and design of the proposed topology have been presented. Simulation is conducted over software package PSIM 9.0.4 to verify the accuracy of the proposed analysis and design. A 500-W prototype has been built and tested in the laboratory to validate the converter performance.

Quasi‐Z‐source interleaved DC‐DC converter for fuel cell vehicle application

Design and control of bi-directional DC/DC converter for 30kW fuel cell power system

Research on High Efficiency DC/DC Converter in Grid-connected Fuel Cell Distributed Power System

Current-fed DC/DC Converter with Reverse Block IGBT for Fuel Cell Distributing Power System

An Interleaved Step-Up/step-down Converter for Fuel Cell Vehicle Applications

A ZVS Three-Port DC-DC Converter Based on Coupled Inductor for Fuel Cell Vehicle

Quasi-Impedance-Source-Network-Based Nonisolated High-Step-Up DC–DC Converter

Wide Input-Voltage Range Boost Three-Level DC–DC Converter with Quasi-Z Source for Fuel Cell Vehicles

A High Step-Up DC to DC Converter under Alternating Phase Shift Control for Fuel Cell Power System

Three-phase interleaved high step-up boost converter with voltage multiplier for fuel cell power system

High Voltage Gain Bi‐directional Z‐source Inverters with Dual‐loop Feed‐forward Peak DC‐link Voltage Compensation for Fuel Cell Vehicles

Novel Interleaved Bidirectional Snubberless Soft-Switching Current-Fed Full-Bridge Voltage Doubler for Fuel-Cell Vehicles

Interleaved High Step-Up Converter with Coupled Inductor and Blocking Capacitor

A High-Step-Up Low-Ripple and High-Efficiency DC-DC Converter for Fuel-Cell Vehicles

Novol Converter of Fuel Cell Vehicles Based on Z-source Inverter

Interleaved ZVT Boost Converters with Winding-Coupled Inductors and Built-In LC Low Pass Output Filter Suitable for Distributed Fuel Cell Generation System

A Novel High-Gain DC-DC Converter Applied in Fuel Cell Vehicles

A High Step-Up DC-DC Converter with Intermediate Capacitor and Coupled Inductors

Theoretical Comparison, Real-Time Emulation, and Experiment Validation of DC/DC Converter for Fuel Cell Electric Vehicle

A High Efficiency Two-Stage ZVS AC/DC Converter with All SiC MOSFET

Coupled inductors-based interleaved boost converters for Fuel Cell Electric Vehicles