Study on the technical and economic requirements to secure a stable and continuous energy supply for fuel cells in buildings in Seoul

Seong Eun Kim,Haejin Kang,Jin Chul Park
DOI: https://doi.org/10.1016/j.applthermaleng.2024.122450
IF: 6.4
2024-02-01
Applied Thermal Engineering
Abstract:In recent years, the utilization rate of fuel cells in buildings in Seoul has been decreasing for techno-economic reasons, including rising liquid natural gas (LNG) prices. This motivated us to investigate the effect of technical and economic variables on the energy performance and economics of fuel cells. The techno-economic conditions under which the fuel cell system of a building in Seoul would become a stable source of energy were derived. In terms of the energy performance and economics of fuel cells, it has the highest influence on the Energy Saving Ratio depending on how much heat energy produced in fuel cells is used. In the given model, the energy savings rate varies by 1–10 % depending on the heat energy use rate and it least 50 % of the heat produced in fuel cells should be used in the building to recover the investment cost. (As of 20 years of life) If fuel cells handle 30 % of the electricity consumption of the building and the building uses 100 % of the generating heat of fuel cells, it can be the most stable energy performance and economy. However, the energy demand of a building is seasonal, especially with respect to the heat consumption. The energy and economic performance are adversely affected from the moment the fuel cell system is unable to use all the waste heat owing to a mismatch between seasonal heat supply and demand. Based on the calculation of the Levelized Cost of Electricity and Heat (LCOE&H) index, in a given model, waste heat is generated by fuel cells designed to afford more than 30 % of the total electricity consumption; thus, the recommendation is to design the fuel cell capacity such that the fuel cell supplies less than 30 % of the electricity requirement. In the research model, if the fuel cell is designed to afford more than 30 %of the total electricity consumption, some of the heat produced in the fuel cell is abandoned. If the electricity rate rises by more than 5 %, the initial investment cost can be recovered within 10 years, and if the 10 % increase, the economic feasibility is met by meeting the Benefit-Cost Ratio > 1, Net Present Value > 0.
energy & fuels,engineering, mechanical,thermodynamics,mechanics
What problem does this paper attempt to address?