Abstract:High resolution electron energy loss spectroscopy (EELS), electron stimulated desorption ion angular distributions (ESDIAD), low energy electron diffraction (LEED), and Auger electron spectroscopy (AES) have been combined to study CO chemisorption on the Cr(110) surface. At 120 K, two molecular binding modes are sequentially populated. The first, α1CO, is a novel binding mode for a clean metal surface in which the molecules are bound with the C–O axis nearly parallel to the Cr(110) surface. These α1CO molecules exhibit a νCO of 1150–1330 cm−1, no detectable ion emission in ESDIAD, and form a c(4×2) α1CO overlayer at saturation (θCO≈0.25). A model is proposed in which the α1CO are π bonded to the Cr(110) surface at twofold symmetric surface hollow sites. Annealing experiments demonstrate that the α1 binding mode is the precursor to dissociation on Cr(110). At higher CO coverages, 0.25<θCO<0.35, the α1CO overlayer is disordered by the addition of the second binding mode, α2CO. Three new vibrations, at 495, 1865, and 1975 cm−1, are observed by EELS while O+ ion emission along the [110] direction is seen in ESDIAD. These α2CO results are indicative of terminally bound molecules adsorbed at atop and bridge sites and aligned approximately perpendicular to the surface. Annealing studies of CO and O/CO adlayers provide evidence for a surface reaction in addition to direct dissociation above 170 K. In contrast, adsorption at 300 K leads to direct dissociative chemisorption with no detectable intermediate molecular adsorbate. The implications of these results to catalytic reactions of CO are considered and comparisons to CO adsorption on clean and ‘‘promoted’’ transition metals are made.

Identification of the surface features in the electronic structure of Cr

Defect structures of the Cr2O3(110) surface: effect of electron beam irradiation

STRONG CHEMISORPTION AND DISSOCIATION OF N2 ON Cr(110) SURFACES

X‐ray standing wave assisted XANES for depth dependent chemical state analysis of Cr in Cr2O3/Cr bilayer structure

Ab initio study of magnetic structure and chemical reactivity of Cr2O3 and its (0001) surface

Defect structures of the Cr<sub>2</sub>O<sub>3</sub>(112̄0) surface: effect of electron beam irradiation

First-principles calculations of spin and angle-resolved resonant photoemission spectra of Cr(110) surfaces at the 2$p$ - 3$d$ resonance

CO chemisorption on Cr(110): Evidence for a precursor to dissociation

Structural twinning-induced insulating phase in CrN (111) films

Surface electronic structure of polar NiO(111) films

Unravelling the atomic and electronic structure of nanocrystals on superconducting Nb(110): Impact of the oxygen monolayer

Defect Structures of the Cr2O3(112̄0) Surface: Effect of Electron Beam Irradiation

Robust Gapless Surface State and Rashba-splitting Bands Upon Surface Deposition of Magnetic Cr on Bi_2Se_3

Structural and spin state transition in the polar NiO(111) surface

Modification of electronic structure and morphology of Ni2MnGa(100) by Cr adlayers

Scanning tunneling spectroscopy study of surface states of 3d metals: Chemical identification, magnetic contrast and orbital Kondo resonance states

Atomic structures and electronic properties of Cr-doped ZnO( ) surfaces

Vibrational study of CO, O2, and H2 Adsorbed on the CoCrFeNi (110) High Entropy Alloy Surface

Weakly-correlated nature of ferromagnetism in non symmorphic CrO$_2$ revealed by bulk-sensitive soft X ray ARPES

Electronic Structures of the SrTiO3(110) Surface in Different Reconstructions.

How metal films de-wet substrates - identifying the kinetic pathways and energetic driving forces