Abstract:Intrinsic stacking fault energy (SFE) values of gamma-Fe and AISI 304 austenitic stainless steels were determined as a function of carbon and nitrogen content using ab initio calculations. In contrast to previous investigations, the analysis was conducted incorporating the paramagnetic state to account for the magnetic constitution of real austenitic stainless steels. The effect of finite temperature was partially accounted for by performing ab initio calculations at the experimental volumes at room temperature. Including paramagnetism in gamma-Fe increases the SFE of non-magnetic gamma-Fe by similar to 385 mJ.m(-2). Interstitial alloying of non-magnetic gamma-Fe causes a linear increase in intrinsic stacking fault energy with interstitial content. In comparison, interstitial alloying of paramagnetic gamma-Fe increases the SFE at only about half the rate. The SFE of paramagnetic interstitial-free AISI 304 is within the range of -12 to 0 mJ.m(-2) and only deviates slightly from the SFE of paramagnetic gamma-Fe. It follows a similar, albeit flatter linear dependency on the interstitial content compared to gamma-Fe. Both gamma-Fe and gamma-AISI 304 were found to be metastable in their interstitial-free condition and are stabilized by interstitial alloying. The possible effect of short range ordering between interstitials and Cr on the SFE was discussed. The calculated threshold nitrogen content necessary to stabilize austenite in AISI 304 is in good agreement with experimental investigations of deformation microstructures in dependence of the nitrogen content. Finally, the calculated negative SFE values of AISI 304 were reconciled with experimentally determined positive SFE values using a recent method that accounts for the kinetics of stacking fault formation.

The Role of Temperature and Magnetic Effects on the Stacking-fault Energy in Austenitic Iron

Effect of Stacking Fault Energy and Austenite Strengthening on Martensitic Transformation in Fe-Mn-Si Alloys

Temperature Dependent Stacking Fault Energy of FeCrCoNiMn High Entropy Alloy

The Influence of Temperature on Stacking Fault Energy in Fe-Based Alloys

Effect of Temperature on the Stacking Fault Energy and Deformation Behaviour in 316L Austenitic Stainless Steel

Predicting the Stacking Fault Energy of Austenitic Fe-Mn-Al (si) Alloys

Stacking-Fault Energy and Anti-Invar Effect in FeMn Alloys

Stacking Fault Energy of C-alloyed Steels: the Effect of Magnetism

Deformation Properties of Austenitic Stainless Steels with Different Stacking Fault Energies

Can experiment determine the stacking fault energy of metastable alloys?

Stacking fault energy of face-centered cubic metals: thermodynamic and ab initio approaches

Strong Temperature – Dependence of Ni -Alloying Influence on the Stacking Fault Energy in Austenitic Stainless Steel

Stacking Fault Energy Determination in Fe-Mn-Al-C Austenitic Steels by X-ray Diffraction

Stacking fault energy prediction for austenitic steels: thermodynamic modeling vs. machine learning

Generalized stacking fault energy of gamma-Fe

Stacking Fault Energy of Face-Centered-cubic High Entropy Alloys

Thermodynamic Calculation of Stacking Fault Energy in Fe–Mn–Si Shape Memory Alloys

Towards stacking fault energy engineering in FCC high entropy alloys

Stacking Fault Energies in Austenitic Stainless Steels

Effects of stacking fault energy on the deformation behavior of CoNiCrFeMn high-entropy alloys: A molecular dynamics study

Ab Initio Study of the Effect of Interstitial Alloying on the Intrinsic Stacking Fault Energy of Paramagnetic Γ-Fe and Austenitic Stainless Steel