Abstract:Numerous studies have focused on numerical investigations of the performance of the shell-and-tube Latent Heat Thermal Energy Storage (LHTES). However, many studies have often overlooked rigorous assessment of key parameters' impact on the numerical simulation accuracy relative to experimental results. Therefore, this paper aims to develop a numerical model to track the solid–liquid interface during phase-changing phenomena in a horizontal LHTES system and investigate the effects of key parameters on the simulation accuracy. For this purpose, an experimental facility was built, and the numerical model was developed in ANSYS using the enthalpy-porosity method. During the simulation of the computational model, consideration was given to thermophysical properties (constant versus variable) of phase change material, contact resistance (zero versus nonzero), and the mushy zone constant (10 5 , 5 × 10 5 , and 10 6 ). The simulation results were compared with experimental data obtained from the in-house studies. The results showed that, compared to using constant thermophysical properties, employing variable thermophysical properties more accurately tracked the solid–liquid interface during melting. It substantially improved the simulation accuracy with a Root Mean Square (RMS) error less than 5 % for most of the temperature-measuring locations. Conversely, variable properties did not make a significant difference in the solidification process. The contact resistance due to the air gap was determined to be 0.035 m 2 ·K/W for the current study. Furthermore, incorporating this resistance resulted in a more accurate approximation of the solid–liquid interface during melting, with RMS errors below 5 % across all locations. The study comparing different mushy zone constants recommended utilizing a slightly higher value of 10 6 for melting, whereas its impact on solidification was found to be insignificant.

Determination of one unknown thermal coefficient through a mushy zone model with a convective overspecified boundary condition

Phase Field Simulation for Non-Isothermal Solidification of Multicomponent Alloys Coupled with Thermodynamics Database

A Novel Investigation of a Micropolar Fluid Characterized by Nonlinear Constitutive Diffusion Model in Boundary Layer Flow and Heat Transfer.

Modeling the Mushy Zone During the Melting Process under Neumann Boundary Condition Using the Improved Enthalpy-Porosity Method

Sensitivity of Numerical Predictions to the Permeability Coefficient in Simulations of Melting and Solidification Using the Enthalpy-Porosity Method

Mushy Zone Equilibrium Solidification of a Semitransparent Layer Subject to Radiative and Convective Cooling

Comparison of Different Numerical Models for Solidification of Paraffin-Based PCMs and Evaluation of the Effect of Variable Mushy Zone Constant

Numerical investigation of a non-linear moving boundary problem describing solidification of a phase change material with temperature dependent thermal conductivity and convection

A monolithic model of solid–liquid phase change problem

Convection in a mushy-layer along a heated wall

Numerical Simulation of Convection in the Two-Phase Zone of a Binary Alloy

Mathematical Model of Unidirectional Solidification with Mushy Layer

Impact of key parameters on the numerical modelling of Phase-Changing phenomena in horizontal latent heat thermal energy storage

Determination of the Thermal Conductivity and Volumetric Heat Capacity of Substance from Heat Flux

Unconstrained melting of phase change material in cylindrical containers inside hot water tanks: Numerical investigation and effect of aspect ratios

On Physical Mechanisms of Mushy Zone Formation in Solidification of Pure Semitransparent Materials

Monolithic simulation of convection-coupled phase-change - verification and reproducibility

Interfacial Analysis and Development of Phase Change Models for Condensation in Openfoam

Melting with natural convection with heterogeneous heating sources

Enhanced numerical modeling of natural heat convective phase change for generalized non-Newtonian fluids at high Rayleigh number

A low Mach enthalpy method to model non-isothermal gas-liquid-solid flows with melting and solidification