Abstract:To study the evolution of stress on the ring and segment interfaces during the construction process of the concrete encapsulation of the main arch ring in a rigid-frame arch bridge, alongside its impact on the ultimate load-bearing capacity of the main arch ring, a 1:10 scale model experiment was conducted by taking the 600 m Tian'e Longtan Bridge as the prototype. The key cross-section concrete strain data were collected during the entire construction process of the main arch ring via fiber-optic strain sensors, which were used to investigate the stress evolution at ring and segment interfaces. ANSYS APDL was employed to simulate the ultimate bearing capacity under various loading conditions of two different finite element models, which were, respectively, formed segmentally and by single pouring. The results revealed that (1) after the closure of the concrete encapsulation of the main arch ring, the concrete stress in the cross-section exhibits significant stress disparities. At the same cross-section, the level of the web concrete stress can reach 76% of the floor concrete stress, while the roof concrete stress level is less than 20% of the floor concrete stress. (2) At the junction of two adjacent work planes, there are considerable differences in the stress levels of the concrete on both sides. After the closure of the main arch ring, the intersegment stress ratios of the floor, web, and roof concrete are 60~70%, 40~60%, and 0~5%, respectively. (3) Loading conditions remarkably affected the ultimate bearing capacity of the main arch ring. Under mid-span loading and 1/4 span symmetrical loading conditions, compared to single-pour concrete encapsulation, the ultimate bearing capacity of the main arch ring with concrete encapsulated by segmented and ring-divided pouring decreased by 19.16% and 5.23%, respectively, compared to single-pour concrete encapsulation. This suggests that the non-uniformity of stress distribution in the concrete sheath can lead to reductions in the ultimate bearing capacity of the arch ring.

Sensitivity of concrete network arch bridges to time‐dependent and thermal effects

Effects of thermal cycles and time-dependent behavior of the deck on steel network arch bridges

Case Study on Stability Performance of Asymmetric Steel Arch Bridge with Inclined Arch Ribs

Damage Characteristics of Thin-Walled Steel Arch Bridges Subjected to In-Plane Earthquake Action

Fatigue Performance Assessment of Composite Arch Bridge Suspenders Based on Actual Vehicle Loads

Impact Factor Characteristics Of Double Parabolic Arch Ribs In A Cfst Arch Bridge Due To Vehicle Loads

Effect of Transverse Earthquake Action on Development of Seismic Damage of Steel Arch Bridges

Finite-element Analysis for Nonlinear Stabilities of Concrete-filled Steel Tubular Arch Bridges

THEORETICAL STUDY ON THE IMPACT FACTOR OF CRESCENT-SHAPED MULTI-RIB CONCRETE FILLED STEEL TUBE TRUSS ARCH BRIDGES

The anti-arch inhibition effect of multispan continuous girder bridge strengthened with prestressed CFRP plates

Strain-temperature Correlation Analysis of a Tied Arch Bridge Using Monitoring Data

Behavior of a Network Tied-Arch Bridge Subjected to Sudden Hanger Loss Scenarios

Simulation Analysis of Thermal Stress of CFST Arch Bridge During Exothermic Hydration Process

Experimental and numerical study of the three-dimensional temperature field in the arch ribs of the reinforced concrete ribbed arch bridge during construction

Mechanical response of long-span CFST arch bridges based on the hydration heat temperature effect

Evolution Law of Concrete Interface Stress of Rigid-Frame Arch under Construction and Its Impact on Ultimate Load-Bearing Capacity

Time-dependent behavior of PC box girder bridges considering non-uniform shrinkage and creep

An Investigation into the Impact of Time-Varying Non-Conservative Loads on the Seismic Stability of Concrete-Filled Steel-Tube Arch Bridges

Thermal Effect on Dynamic Characteristics of Concrete Girder Bridges

Reinforced Concrete Multi-Rib Arch Bridge Strengthened by Changing Structural System

Analysis of temperature-induced deformation and stress distribution of long-span concrete truss combination arch bridge based on bridge health monitoring data and finite element simulation