Abstract:Introduction. Currently, a substantial proportion of the machine-building industry is made up of one-off products or products manufactured in small batches. In this regard, innovative approaches to obtaining such products are being actively applied in order to reduce the cost of special, expensive tooling of the blanking process. Such technologies include the Direct Metal Deposition (DMD) method, the essence of which is the deposition of metal particles from a gas-powder stream. This method has a lot of advantages, but one of the main drawbacks is that the products after growing have a rough surface and do not meet the accuracy requirements of the finished part drawing. Consequently, the parts require further machining by cutting. However, due to the novelty of the materials, there are no regime parameters for machining. In this regard, the aim of the work is to establish the functional relationship between the cutting force and roughness of the machined surface with the feed per tooth during end milling of EuTroLoy 16604 material formed by DMD-method. In this paper an experimental study of cutting force and roughness of machined surface with varying the tooth feed during end milling is carried out. The research method is an experiment on milling of EuTroLoy 16604 material obtained by DMD-method with measuring the output parameters of the process (cutting force and roughness of the machined surface). Results and discussion. The measured values of cutting force and roughness of the machined surface allowed establishing functional and graphical dependences of the output parameters of the milling process on the feed per tooth. It is found that using a cutter with a smaller clearance angle results in lower cutting forces and the surface has a lower height of microroughness. Thus, the developed functional relationships of cutting force and roughness of the machined surface with the feed per tooth allow predicting the output parameters of the cutting process and increasing the efficiency of machining operations by cutting. A promising direction for further work is seen in the study of relative machinability and evaluation of its quantitative value.

A Study of 2D Roughness Periodical Profiles on a Flat Surface Generated by Milling with a Ball Nose End Mill

Geometry Simulation and Evaluation of the Surface Topography in Five-Axis Ball-End Milling

Theoretical investigation on the flank milled roughness profile in quasi-homogeneous materials

Study on Analytical Model of Surface Roughness Prediction in NC Machining

Modelling and Optimization of Machined Surface Topography in Ball-End Milling Process

A Processing Technical Analysis for the Characteristics of Forces and Surface Roughness in Micro-Scale Milling

Theoretical and Experimental Investigation of Surface Textures in Vibration-Assisted Micro Milling

Optimization of surface roughness in ball-end milling using teaching-learning-based optimization and response surface methodology

A study of the relationship between cutting force and machined surface roughness with the feed per tooth when milling EuTroLoy 16604 material produced by the DMD method

Mathematical modeling and experimental verification of surface roughness in micro-end-milling

Modeling and Analysis of Micro Surface Topography from Ball-End Milling in a Trochoidal Milling Mode

Theoretical Modeling and Surface Roughness Prediction of Microtextured Surfaces in Ultrasonic Vibration-Assisted Milling

A study of surface roughness variation in ultrasonic vibration-assisted milling

Surface quality analysis in ball end milling of Inconel 718 cantilevers by response surface methodology

Study on ploughing phenomena in tool flank face workpiece interface including tool wear effect during ball end milling

Effect of the Relative Position of the Face Milling Tool towards the Workpiece on Machined Surface Roughness and Milling Dynamics

Study on 3D topography of machined surface in high-speed hard cutting with PCBN tool

Modelling and experimental investigation on textured surface generation in vibration-assisted micro-milling

Analysis on significance of various statistical texture features in vision-based surface roughness prediction in end milling process

Research on Homogenization and Surface Integrity of Ti-6Al-4V Alloy by Longitudinal-Torsional Coupled Ultrasonic Vibration Ball-End Milling

Comparison in surface integrity and fatigue performance for hardened steel ball-end milled with different milling speeds