Abstract:<h3>Background</h3><p>The measurement of finger and wrist range of motion (ROM) is of great importance to clinicians when assessing functional outcomes of therapeutic interventions and surgical procedures. The purpose of the study was to assess the repeatability of ROM measurements of the hand joints with manual goniometer and 3D motion capture system and to calculate the minimal detectable difference for both methods.</p><h3>Methods</h3><p>Active finger and wrist joints ROM of 20 healthy volunteers were assessed using a manual goniometer and 3D motion capture system. Minimal detectable difference (MDD) and standard error of measurement (SEM) were calculated for both measurement systems and compared within the same task. Maximal ROM of all joints was registered twice on two different days to evaluate the test-retest repeatability. The intraclass correlation coefficients (ICC) was calculated and examined to determine if reliability ≥ 0.70 existed.</p><h3>Results</h3><p>MDD for the 3D motion capture was between 5 and 12° except for the metacarpophalangeal joint (MCP) 1, interphalangeal joint (IP), and MCP5. SEM values lay between 2 and 4° for all joints except for the MCP5, IP, and MCP1. For the goniometric measurements, MDD and SEM were between 12–30° and 4–11°, respectively. The reliability criterion (ICC > 0.7) was achieved for the ROM measurement with the 3D motion capture system for 94% of the joints and in only 65% of the joints with the manual goniometer.</p><h3>Conclusions</h3><p>Joint ROM assessed with 3D motion analysis showed higher test-retest agreement demonstrating overall better repeatability for this method. Because of the smaller measurement error, the 3D motion capture system has a smaller MDD. Only individual test-rest differences bigger than the MDD can be considered as real changes, and therefore, in an experimental situation, the use of a more precise measurement method can greatly reduce the number of subjects needed for a statistical significance. Goniometer measurements of some joints should be carefully interpreted, due to a low repeatability and reliability.</p><h3>Trial registration</h3><p>This study is approved by the Ethical Committee Zurich (<span><a href="https://kek.zh.ch/"><span>Kek-ZH-Nr: 2015-0395</span></a></span>).</p>

Digital workflow to measure the mandibular range of motion using different jaw tracking technologies

An automatic tracking method to measure the mandibula movement during real time MRI

Investigation of the precision of a novel jaw tracking system in recording mandibular movements: A preliminary clinical study

Implementing an optical jaw tracking system to locate centric occlusion: A dental technique

Integrating the repeatable reference position and excursive movements of the mandible acquired using a jaw tracker into the design procedures of an occlusal device: A technique

Digital Determination and Recording of Edentulous Maxillomandibular Relationship Using a Jaw Movement Tracking System

Computerized occlusal analysis - innovative approaches for a practice-oriented procedure

Comparative analysis of three jaw motion tracking systems: A study on precision and trueness

Real-time three-dimensional jaw tracking in temporomandibular disorders

Accuracy of a Real-Time, Computerized, Binocular, Three-Dimensional Trajectory-Tracking Device for Recording Functional Mandibular Movements.

Computer-monitored radionuclide tracking of three-dimensional mandibular movements. Part I: theoretical approach

Full-Digital Workflow for TMDs Management: A Case Series

The use of dynamic CT imaging for tracking mandibular movements in a phantom

Digital diagnostic occlusal equilibration combining an intraoral scanner, optical jaw tracking system, and dental design program: A dental technique

A New Virtual Dynamic Dentomaxillofacial System For Analyzing Mandibular Movement, Occlusal Contact, And Tmj Condition

Accuracy of a new photometric jaw tracking system in the frontal plane at different recording distances: An in-vitro study

A digital workflow in the treatment of patients with temporomandibular joint disorders: a case report

A digital approach to the evaluation of mandibular position by using a virtual articulator

Feasibility study of the application of magnetic resonance elastography (MRE) to measure oral posture related changes in stiffness of zygomaticus major muscle

Minimal detectable difference of the finger and wrist range of motion: comparison of goniometry and 3D motion analysis

A Method of Three-Dimensional Recording of Mandibular Movement Based on Two-Dimensional Image Feature Extraction.