Abstract:Phase change materials (PCMs) are materials that can store large amounts of heat during their phase transition from solid to liquid without a significant increase in temperature. While going from liquid to solid this heat is again released. As such, these materials can play an important role in future energy-efficient buildings. If applied in facades as part of a thermal buffer strategy, e.g., capturing and temporarily storing solar energy in so-called Trombe walls, the PCMs are exposed to high solar radiation intensities, which may easily lead to issues of overheating. This paper therefore investigates the melting process of PCM and arrives at potential solutions for countering this overheating phenomenon. This study uses the simulation program Comsol to investigate the heat transfer through, melting of and fluid flow inside a block of PCM (3 × 20 cm2) with a melting temperature of around 25 °C. The density, specific heat and dynamic viscosity of the PCM are modeled as a temperature dependent variable. The latent heat of the PCM is modeled as part of the specific heat. One side of the block of PCM is exposed to a heat flux of 300 W/m2. The simulations show that once part of the PCM has melted convection arises transporting heat from the bottom of the block to its top. As a result, the top heats up faster than the bottom speeding up the melting process there. Furthermore, in high columns of PCM a large temperature gradient may arise due to this phenomenon. Segmenting a large volume of PCM into smaller volumes in height limits this convection thereby reducing the temperature gradient along the height of the block. Moreover, using PCMs with different melting temperature along the height of a block of PCM allows for controlling the speed with which a certain part of the PCM block starts melting. Segmenting the block of PCM using PCMs with different melting temperature along its height was found to give the most promising results for minimizing this overheating effect. Selecting the optimal phase change temperatures however is critical in that case.

Phase change front tracking methods in a vertical tube-in-tube phase change material heat exchanger

A Novel Indirect Visualization Method for Studying the Melting Heat Transfer of Nano-Enhanced Phase Change Materials Using Thermochromic Liquid Crystal Thermography

An Experimental Investigation of Constrained Melting Heat Transfer of Nano-Enhanced Phase Change Materials in a Horizontal Cylindrical Capsule Using Thermochromic Liquid Crystal Thermography

A volume-shrinkage-based method for quantifying the inward solidification heat transfer of a phase change material filled in spherical capsules

Investigation of numerical and experimental assessment of melting behavior of phase change material in U tube heat exchanger

Numerical analysis of phase-change material melting in triplex tube heat exchanger

Experimental and numerical analysis of a phase change material-based shell-and-tube heat exchanger for cold thermal energy storage

Heat transfer mechanism in solar thermal energy storage systems using phase change materials

Phase Change Material numerical simulation: enthalpy-porosity model validation against liquid fraction data from an X-ray computed tomography measurement/system

Heat transfer processes during an unfixed solid phase change material melting outside a horizontal tube

Computational study on transient thermal performance enhancement of phase change materials in triplex tube heat exchanger through novel annular-finned configurations

Investigation on the Melting Performance of a Phase Change Material Based on a Shell-and-Tube Thermal Energy Storage Unit with a Rectangular Fin Configuration

Temperature Control in (Translucent) Phase Change Materials Applied in Facades: A Numerical Study

Analytical modeling of phase change in a composite wall comprising two distinct phase change materials in series

Experimental Investigation on the Characteristics of Melting Process of Phase Change Material in Horizontal Annulus

Experimental investigation of thermal performance in a shell-and-tube phase change thermal energy storage unit with an inner square tube

A solid–liquid model based on lattice Boltzmann method for phase change material melting with porous media in cylindrical heat exchangers

Analysis of heat transfer and fluid flow during the melting process of PCM within tubular thermal energy storage unit

Visualized experiment on solid-liquid phase change heat transfer enhancement with multiple PCMs

Dual-sided melting of a one-dimensional composite wall comprising two distinct phase change material (PCM) layers

Experimental and numerical research on thermal characteristics of phase change thermal storage device