Abstract:Cauchy-elastic solids include hyper-elasticity and a subset of elastic materials for which the stress does not follow from a scalar strain potential. More in general, hypo-elastic materials are only defined incrementally and comprise Cauchy-elasticity. Infringement of the hyper-elastic 'dogma' is so far unattempted and normally believed to be impossible, as it apparently violates thermodynamics, because energy may be produced in closed strain cycles. Contrary to this belief, we show that non-hyper-elastic behavior is possible and we indicate the way to a practical realization of this new concept. In particular, a design paradigm is established for artificial materials where follower forces, so far ignored in homogenization schemes, are introduced as loads prestressing an elastic two-dimensional grid made up of linear elastic rods (reacting to elongation, flexure and shear). A rigorous application of Floquet-Bloch wave asymptotics yields an unsymmetric acoustic tensor governing the \textit{incremental} dynamics of the effective material. The latter is therefore the incremental response of a hypo-elastic solid, which does not follow from a strain potential and thus does not belong to hyper-elasticity. Through the externally applied follower forces (which could be originated via interaction with a fluid, or gas, or by application of Coulomb friction, or non-holonomic constraints), the artificial material may adsorb/release energy from/to the environment and therefore produce energy in a closed strain loop, without violating any rule of thermodynamics. The solid is also shown to display flutter, a material instability corresponding to a Hopf bifurcation, which was advocated as possible in plastic solids, but never experimentally found and so far believed to be impossible in elasticity.

Extraordinary stiffness tunability through thermal expansion of nonlinear defect modes

Incremental constitutive tensors and strain localization for prestressed elastic lattices: Part II -- incremental dynamics

Implementation of tunable frequency-dependent stiffness elements via integrated shunted piezoelectric stacks

Enhanced sensitivity and tunability of thermomechanical resonance near the buckling bifurcation

Incremental constitutive tensors and strain localization for prestressed elastic lattices: Part I -- quasi-static response

A Novel 3D-Printed Negative-Stiffness Lattice Structure with Internal Resonance Characteristics and Tunable Bandgap Properties

Local-to-non-local transition laws for stiffness-tuneable monoatomic chains preserving springs mass

Non-reciprocal wave phenomena in spring-mass chains with effective stiffness modulation induced by geometric nonlinearity

Tunable defect states of flexural waves in magnetostrictive phononic crystal beams by magneto-mechanical-thermal coupling loadings

Nonlinear deformation and elasticity of BCC refractory metals and alloys

Elasticity tunes mechanical stress localization around active topological defects

Tuning Negative Stiffness Mechanical Metamaterial’s Snap-through Behavior with a Series-Connected Spring

Size effect anomalies in the behaviour of loaded 3D mechanical metamaterials

Strong nonlinearity and external high-frequency forcing for controlling effective mechanical stiffness: theory and experiment

Effects of strain stiffening and electrostriction on tunable elastic waves in compressible dielectric elastomer laminates

A way to hypo-elastic artificial materials without a strain potential and displaying flutter instability

Vibrations and transitions across barrier of strained nanoribbons at finite temperature

2D Mechanical Metamaterials with Widely Tunable Unusual Modes of Thermal Expansion

Mechanical Control of Nonlinearity in Doubly Clamped MEMS Beam Resonators Using Preloaded Lattice-Mismatch Strain