Abstract:Viscoelastic fibre-reinforced composite materials have a number of possible advantages for use in underwater acoustic applications. In order to exploit these materials it is important to be able to measure their complex stiffness matrix in order to determine their acoustic response. Ultrasonic transmission measurements on parallel-sided samples, employing broadband pulsed transducers at 2.25 MHz and an immersion method, have been used to determine the viscoelastic properties of a glass-reinforced composite with uniaxially aligned fibres. The composite measured was constructed from Cytecfiberite's CYCOM 919 E-glass. The theory of acoustic propagation in anisotropic materials shows that the direction of energy propagation is, in general, different from that given by Snell's Law. At 15 degrees incidence, Snell's Law implies a refracted angle of 40 +/- 2 degrees, whereas the energy direction is observed to be 70 +/- 2 degrees. Despite this, the experimental data indicates that the position of the receiving transducer has relatively little effect on the apparent phase velocity measured. The phase velocities measured at positions determined from the refracted angle and energy direction are 3647 and 3652 +/- 50 m s(-1), respectively. However, the amplitude of the received signal, and hence estimate of attenuation, is highly sensitive to the receiver position. This indicates that the acoustic Poynting vector must be considered in order to precisely determine the correct position of the receiving transducer for attenuation measurements. The beam displacement for a 17.6 mm sample at 15 degrees incidence is 9.5 and 40 mm by Snell's Law and Poynting's Theorem, respectively. Measured beam displacements have been compared with predictions derived from material stiffness coefficients. These considerations are important in recovering the complex stiffness matrix.

Pulse-echo method can't measure wave attenuation accurately

Measurement of the Echo Reduction for Passive Materials Based on Inverse Filtering Technique

Pulse-echo Acoustic Properties Evaluation Method Using High-Frequency Transducer

Fourier Spectrum Pulse-Echo for Acoustic Characterization

Fourier Transform Ultrasound Spectroscopy for the determination of wave propagation parameters

Sound Absorption Measurement in a Circular Tube Using the Echo-Pulse Method

Sound Absorption Measurement in a Circular Pipe with the Echo-pulse Method

Measurement of sound absorption coefficient in an impedance tube using echo-pulse method

Acoustic attenuation coefficient measurement in extreme environments: Experimental characterization of uncertainty in multiple-reflection method

Comparison of P‐wave Attenuation Models of Wave‐induced Flow

Experimental Study of Diffraction and Waveguide Effects in Ultrasonic Attenuation Measurements

Energy and phase velocity considerations required for attenuation and velocity measurements of anisotropic composites

An Adaptive Algorithm for Accurate Estimation of Pulse-Wave Velocity and Attenuation

Measurement of Sound Transmission Loss in an Acoustic Pipe Using Pulse Method

Frequency-dependent attenuation reconstruction with an acoustic reflector

Experimental Measurement of Velocity Dispersion and Wave Attenuation at Seismic Frequency

A Method for Calculating Attenuation in Creeping Materials

Digital Ultrasonic Pulse-Echo Overlap System and Algorithm for Unambiguous Determination of Pulse Transit Time

Determination of the absolute nonlinear parameters using a pulse-echo method in a terminal impedance-mismatched system

Diffraction effects on bulk-wave ultrasonic velocity and attenuation measurements

Attenuation Imaging with Pulse-Echo Ultrasound based on an Acoustic Reflector