Abstract:A discrete element method (DEM) model is developed to simulate the dynamics of wet, flexible fibers. The angles of repose of dry and wet fibers are simulated, and the simulation results are in good agreement with experimental results, validating the wet, flexible fiber model. To study wet fiber flow behavior, the model is used to simulate shear flows of wet fibers in a periodic domain under Lees-Edwards boundary conditions. Significant agglomeration is observed in dilute shear flows of wet fibers. The size of the largest agglomerate in the flow is found to depend on a Bond number, which is proportional to liquid surface tension and inversely proportional to the square of the shear strain rate. This Bond number reflects the relative importance of the liquid-bridge force to the particle's inertial force, with a larger Bond number leading to a larger agglomerate. As the fiber aspect ratio (AR) increases, the size of the largest agglomerate increases, while the coordination number in the largest agglomerate initially decreases and then increases when the AR is greater than four. A larger agglomerate with a larger coordination number is more likely to form for more flexible fibers with a smaller bond elastic modulus due to better connectivity between the more flexible fibers. Liquid viscous force resists pulling of liquid bridges and separation of contacting fibers, and therefore it facilitates larger agglomerate formation. The effect of liquid viscous force is more significant at larger shear strain rates. The solid-phase shear stress is increased due to the presence of liquid bridges in moderately dense flows. As the solid volume fraction increases, the effect of fiber-fiber friction coefficient increases sharply. When the solid volume fraction approaches the maximum packing density, the fiber-fiber friction coefficient can be a more dominant factor than the liquid bridge force in determining the solid-phase shear stress.

Simulating flexible fiber suspensions using a scalable immersed boundary algorithm

Discrete element simulation studies of angles of repose and shear flow of wet, flexible fibers.

A fast platform for simulating flexible fiber suspensions applied to cell mechanics

Coarse-graining the dynamics of immersed and driven fiber assemblies

Simulation of fiber suspension flowing through a stock pump impeller with two-way coupling

Microstructures of fiber suspensions in complex geometry

Numerical simulation on velocities of two interacting fibers in fiber suspension

Efficient simulation of non-crossing fibers and chains in a hydrodynamic solvent

Numerical Investigation of Three-Dimensional Fiber Suspension Flow by Using Finite Volume Method

Dynamics of flexible fibers in confined shear flows at finite Reynolds numbers

Numerical simulation of two-dimensional squeeze-expansion flow of fiber suspensions

Sph Simulations of 2d Transient Viscoelastic Flows Using Brownian Configuration Fields

Numerical Investigation of Nonlinear Fluid–structure Interaction Dynamic Behaviors under a General Immersed Boundary-Lattice Boltzmann-Finite Element Method

Numerical Study on Fiber Suspensions in Non-Isothermal Viscoelastic Media

Multi-scale mathematic modeling of non-isothermal polymeric flow of fiber suspensions

Simulation of fluid − flexible structure interaction

Rheological Properties of Fiber Suspensions Flowing Through a Curved Expansion Duct

SPH simulations of three-dimensional non-Newtonian free surface flows

A Bonded Sphero-Cylinder Model for the Discrete Element Simulation of Elasto-Plastic Fibers

Numerical Prediction of Fiber Motion in A Branching Channel Flow of Fiber Suspensions

Efficient Convergent Boundary Integral Methods for Slender Bodies