Abstract:This paper describes the extensive Wind Tunnel (WT) linear cascade testing campaign carried out on a constant section turbine blade developed for low subsonic applications. Comprehensive experimental program was designed to determine the aerodynamic behaviour of this blade under a wide range of varying geometrical like Pitch to Chord Ratio, Stagger Angle and Aerodynamic like Reynolds Roughness, Mach number, Incidence angle conditions. In addition to the classical Two-Dimensional (2D) measurements, targeted Three-Dimensional (3D) surveys have been performed to complement the 2D results, allowing to draw supplementary conclusions as to the behaviour of the considered blade in three-dimensions. The performed experiments predominantly covered the transitional and beginning of a fully turbulent flow regime (maximum Re is 2.5 million). Post processing of experimental results were done in view of exploitation and judgment of some key aerodynamic aspects; parameters such as profile section load distribution, loss coefficient and flow deviation angle. Alongside with confirmation of the design targets, a parallel goal pursued in the current WT testing, was to get a more accurate idea as to the predictive capabilities of the employed CFD tools (CFX and MISES) under the basic flow condition generated in the WT. The aim was to get a global picture, as to the level of agreement that can be reached by the used design tools while accounting for the afore-mentioned design, operational variables. The obtained measurement results clearly indicated the success of the design in achieving the pre-set targets. The paper further provides a detailed discussion on the identified discrepancies, measurement versus predictions, of the key parameters at the geometric, aerodynamic design as well as off-design conditions.

CFD Simulation of the NREL Phase VI Rotor

Les and Cdns Investigation of T106c Low Pressure Turbine

Large Eddy Simulation and CDNS Investigation of T106C Low-Pressure Turbine

CFD simulations of aerodynamic characteristics for the three-blade NREL Phase VI wind turbine model

Numerical simulation of internal flow in forward-curved centrifugal fan

Prediction of the near wall flow behaviours of separation and transition for NREL phase VI wind turbine blade

Investigations of Flow Field with Different Turbulence Models on NREL Phase VI Blade

3-D numerical simulation of aerodynamic performance of horizontal-axis wind turbine

Numerical simulation of 3D viscous flow field of wind turbine under nonuniform wind

Development and Validation of a CFD Technique for the Aerodynamic Analysis of HAWT

Aerodynamic Performance Prediction of NREL Phase VI Blade Adopting Biplane Airfoil

Determination of the geometric and material properties of the NREL Phase VI wind turbine blade

Simulation of low-speed separated flows for the NREL airfoil at high angles of attack

Numerical Simulations of the NREL Phase VI Wind Turbine with Low-Amplitude Sinusoidal Pitch

A comprehensive CFD investigation of tip vortex trajectory in shrouded wind turbines using compressible RANS solver

Numerical Simulation of a Wind Turbine Airfoil: Dynamic Stall and Comparison with Experiments

Analysis of Turbulent Separated Flows for the NREL Airfoil Using Anisotropic Two-Equation Models at Higher Angles of Attack

Wind Tunnel Testing and Modeling Implications of an Advanced Turbine Cascade

Turbulence Resolving Flow Simulations of a Francis Turbine in Part Load using Highly Parallel CFD Simulations

Validation of a RANS CFD Model for a S833 Wind Turbine Airfoil with a Trailing Edge Flap Using Oil Visualization and Pressure Taps

Radial flow on aft-swept wind turbine blades