Abstract:S urface a coustic w ave (SAW) devices are subject to thermomechanical coupling during operation, and when the temperature rises sharply to 180 °C, the surface of the lithium niobate crystal substrate generates nonuniform thermal stresses, thus leaving large residual stresses after complete cooling, which seriously influences its service performance and life. In this study, the thermal residual stresses of lithium niobate wafers were tested by nanoindentation tests, and the nanoindentation test process was simulated. The inverse calculation of the parameters of the lithium niobate constitutive model was carried out by comparing the load-displacement curves obtained from the finite element calculations with the experimental results. A multiscale model of the SAW device was established, its operation process was simulated, and then the generation law of residual stress was further discussed. The nanoindentation test results show that the thermal residual stress is positively correlated with the heating time under the effect of the same temperature; however, at the heating temperature up to about 180 °C, the lithium niobate crystal enters the high-temperature hyperelastic interval, and the yield stress of the crystal increases significantly at this stage. The constitutive model curves obtained by finite element calculations are in good agreement with the experimental results, and the thermal residual stress value of lithium niobate can reach 2/3 of its yield stress outside the high-temperature hyperelastic interval by comparison tests. The calculation results of the multi-scale model of the SAW device indicate that excessive thermal stress is the main cause of damage during the thermo-mechanical coupling of the SAW device. The polarization direction of lithium niobate crystals may cause the development of damage cracks, increasing the heat dissipation can effectively reduce the thermal stress to which it is subjected, and better extend the service life of the SAW device.

The influence of van der Waals forces on the waveguide deformation and power limit of nanoscale optomechanical systems

Influence of Van Der Waals Forces on the Waveguide Deformation and Power Limit of Nanoscale Waveguide Devices

General Existence of Flexural Mode Doublets in Nanowires Targeting Vectorial Sensing Applications

Analysis and Optimization of a Novel Laterally Deformable Optical NEMS Grating Transducer

High-power Continuous-Wave Optical Waveguiding in a Silica Micro/nanofibre.

10-W-level CW waveguiding in an optical micro/nanofiber

Influence of Optical Forces on Nonlinear Optical Frequency Conversion in Nanoscale Waveguide Devices.

Giant Transverse Optical Forces in Nanoscale Slot Waveguides of Hyperbolic Metamaterials

Rigorous analysis of Casimir and van der Waals forces on a silicon nano-optomechanical device actuated by optical forces

Vibration Analysis of Fluid-Conveying Nanotubes Embedded in an Elastic Medium Considering Surface Effects

Effects of van der Waals force on nonlinear vibration of electromechanical integrated electrostatic harmonic actuator

Roughness-induced Radiation Losses in Optical Micro or Nanofibers.

Precise and Omnidirectional Opto‐Thermo‐Elastic Actuation in Van Der Waals Contacting Systems

Optical Force on Dielectric Nanorods Coupled to A High-Q Photonic Crystal Nanocavity

Nanomotion of Micro-Objects Driven by Light-Induced Elastic Waves on Solid Interfaces

Cavity nano-optomechanics in the ultrastrong coupling regime with ultrasensitive force sensors

Slow-light enhanced optical forces between longitudinally shifted photonic-crystal nanowire waveguides

Micro-scale opto-thermo-mechanical actuation in the dry adhesive regime

Interface Thermal Conductivities Induced by Van Der Waals Interactions

Investigation on effects of thermo-mechanical coupling on residual stress in lithium niobate in surface acoustic wave device

Optomechanical Contribution to the Intensity-Dependent Refractive Index of Optical Microfibers and Nanofibers