Wide-Angle Scanning Parallel-Plate Lens in Multilayer PCB Technology

Thomas Ströber,Léonin Lassauce,Xavier Morvan,Hervé Legay,George Goussetis,Mauro Ettorre
DOI: https://doi.org/10.1109/tap.2024.3424316
IF: 5.7
2024-10-08
IEEE Transactions on Antennas and Propagation
Abstract:This article presents the design of a dual-lens beamformer in multilayer printed circuit board (PCB) technology. The proposed lens is implemented in a dielectric parallel-plate waveguide (PPW), offering enhanced scanning performances along with a compact design. A combination of ray-tracing and conjugate field matching is used to design the lens and feed configuration. The concept is validated by a prototype operating in the downlink K-band allocated to satellite communications (17.3–20.2GHz). The shaped lens is machined from a stack of substrate layers, while the integrated feed system is realized using standard PCB techniques. The final structure produces nine stable beams over an angular sector of ±60° (±10 beamwidths) from a flared linear aperture of about . Good agreement between the simulated and experimental results is obtained. The measured return loss is better than 10dB, and port-to-port isolation is greater than 17dB over the entire frequency band. The estimated radiation efficiency of the antenna is about 75%, and maximum scan losses are in the order of 2dB.
telecommunications,engineering, electrical & electronic
What problem does this paper attempt to address?