Abstract:Abstract A radiofrequency (RF) ion source with a megawatt power extraction, thunder I, has been developed for the neutral beam injector (NBI) on HL-2A tokamak. A full solid-state RF generator with output power of 80 kW and frequency of 2 MHz was built by an RF combiner using 8 modules of solid-state RF generator with power of P RF = 10 kW. The line electric efficiency of whole RF generator reaches 92% and its voltage standing wave ratio (VSWR) is 1.01, thus no water-cooling system is supplied. A quartz vessel with the inner diameter of 250 mm is directly adopted for resisting atmospheric pressure, which can dramatically simplify source structure. Nowadays, the extracted beam parameters of RF hydrogen ion source are 32 kV/20 A/0.1 s on a test bed, while the design parameters are 50 kV/20 A/3 s. The beam density profile measured by the infrared imaging technique at 1.3 m downstream from the grounded grid obeys a Gaussian distribution, and the corresponding half width of 1/ e power decay at the matched condition is about 80 mm. Plasma homogeneity is over 90% at low RF power. The beam divergence angle meets the requirement of NBI system on HL-2A tokamak. The extractable current density increases almost linearly with the RF power. It reaches 2400 A m −2 at P RF = 32 kW. The ion density in front of plasma grid is about 1 × 10 18 m −3 , corresponding to an ionized fraction of about 1% at the gas pressure of 0.5 Pa. Single hydrogen ion fraction reaches 79% at the beam current of 12.4 A. Some improvements have been considered for optimizing ion source performance on next experimental campaign. One smaller auxiliary RF discharge chamber equipped with a gas feed path, driven by 13.56 MHz/3.5 kW generator, is connected to main discharge chamber driven by 2 MHz/40 kW generator. By this dual-driven configuration, the innovative RF plasma source with high-pressure density gradient solves the initial ignition problem of powerful RF ion source even if the gas pressure below 0.1 Pa. In addition, the RF negative hydrogen ion source of 200 kV/20 A/3600 s is also developed at SWIP for the China fusion engineering test reactor.

Renovation of the IPM-2 Source Ion-Optical System for the Globus-M2 Spherical Tokamak Neutral Beam Injector

Conceptual design of 5 MW-NBI injector for HL-2 M tokamak

High-Power Ion Beam Characteristics of a Magnetic Multi-Pole Line-Cusp Ion Source for the HL-2A Tokomak

Neutral Injection Complex for Globus-M2 Spherical Tokamak

Update of ion-optical system of neutral beam of Tokamak à Configuration Variable

Hot Ion Mode in the Globus-M2 Spherical Tokamak

Plasma Stored Energy Analysis during Neutral Beam Injection in the Globus-M2 Tokamak Using the PET Equilibrium Code and Diamagnetic Measurements

Measurement of the fast ion distribution using active NPA diagnostics at the Globus-M2 spherical tokamak

Upgrade of the Diagnostic Neutral Beam Injector for the RFX-mod2 experiment

Study of plasma heating in ohmically and auxiliary heated regimes in spherical tokamak Globus-M

Development of megawatt radiofrequency ion source for the neutral beam injector on HL-2A tokamak

Effect of Locked MHD Modes on the Efficiency of Plasma Heating by the Neutral Beam Injection Method at the Globus-M2 Spherical Tokamak

Beam Optics Analysis for the 120-keV Multiaperture Accelerator of Neutral Beam Injector

Modular NBI heating system with high current microwave ion source for fusion reactors

Tomography diagnostic of plasma radiated power on the spherical tokamak Globus-M

Correlation of source parameters and beam properties in the early operation of the full size ITER negative ion beam source

Upgrade of the Neutral Beam Injection System on EAST

The Power Supply System of Ion Source for Nbi

Laser Plasma Ion Source for Intense Heavy Ion Beams (Abstract)

Confinement, heating, and current drive study in Globus-M2 toward a future step of spherical tokamak program in Ioffe Institute

Overview of neutral beam injectors for plasma heating and diagnostics developed at Budker INP