Abstract:A two-stage biodiesel production directly from wet microalgae (Chlorella vulgaris) assisted by radio frequency (RF) heating was optimized in this study with the response surface methodology (RSM) applied to both two steps. In order to apply RSM to the two stages rather than to a one-step reaction, a three-variable, five-level central composite design (CCD) was employed to evaluate the effects of three key parameters, i.e. HCl to MeOH ratio (v/v), MeOH volume, and RF heating time. Two regression equations (one regression equation for each stage) were obtained, and two sets of optimized production conditions with a slight difference were also determined. The best predicted FAME yield of 93.1% was obtained at a HCl to MeOH ratio of 4.27 (v/v), a MeOH volume of 28.5 mL, and a RF heating time of 19.2 min. Although the second stage of conversion increased the FAME yield from 82.9% to 93.1%, this process would cause additional consumption of time, solvent, and energy. Verification experiments were carried out at the optimized point and resulted in a yield of 92.7 ± 0.1%, which validated the reliability of the prediction model. All processing steps, including cell destruction, esterification, and transesterification, were carried out at temperatures below 100°C and atmospheric pressure. Therefore, no pressure-proof nor high-temperature apparatus was required. The procedure shows great potential for industrial application because of its high FAME yield, simple operation, low chemical consumption, and short processing time. The principles of the procedure can also be applied to other microalgae with high lipid contents.

Thermal-Fenton mechanism with sonoprocessing for rapid non-catalytic transesterification of microalgal to biofuel production

In Situ Ethyl Ester Production from Wet Algal Biomass under Microwave-Mediated Supercritical Ethanol Conditions

CO2 capture/biofixation and lipid extraction by membrane contactors for enhancing microalgal cultivation

Biofuel production from wet microalgae biomass: Comparison of physicochemical properties and extraction performance

Enzymatic Ethanolysis Subjected to Schizochytrium Biomass: Sequential Processing for DHA Enrichment and Biodiesel Production

Electro-Fenton Based Technique to Enhance Cell Harvest and Lipid Extraction from Microalgae

Combination of cell disruption method and pH variation as pre-treatment for lipid extraction of Nannochloropsis sp.

Processing wet microalgae for direct biodiesel production: optimization of the two-stage process assisted by radio frequency heating

Lipase-catalyzed methanolysis of microalgae oil for biodiesel production and PUFAs concentration

In Situ Transesterification of Microalgae with High Free Fatty Acid Using Solid Acid and Alkali Catalyst.

In Situ Enzymatic Conversion of Nannochloropsis oceanica IMET1 Biomass into Fatty Acid Methyl Esters

Alkali-Catalyzed Transesterification of Lipid from Chlorella Sp. USTB-01 to Biodiesel

Rapid extraction of lipid from wet microalgae biomass by a novel buoyant beads and ultrasound assisted solvent extraction method

Catalytic Conversion of Chlamydomonas to Hydrocarbons Via the Ethanol-Assisted Liquefaction and Hydrotreating Processes

Photothermal technique-enabled ambient production of microalgae biodiesel: Mechanism and life cycle assessment

Combined Enzymatic and Mechanical Cell Disruption and Lipid Extraction of Green Alga Neochloris oleoabundans

Maximizing Lipid Extraction from Chlorella pyrenoidosa: A Study on the Effectiveness of Cell Disruption Techniques

Efficient Biodiesel Conversion From Microalgae Oil Of Schizochytrium Sp.

Production of High-Quality Biofuel Via Ethanol Liquefaction of Pretreated Natural Microalgae

Simultaneous Cell Disruption and Lipid Extraction in a Microalgal Biomass Using a Nonpolar Tertiary Amine

Two-step in Situ Biodiesel Production from Microalgae with High Free Fatty Acid Content