Abstract:Dual face-centered cubic (FCC) CoCrCu1.2FeNi semi-solid billets were prepared by semisolid isothermal treatment of wrought high entropy alloy (HEA) (SSITWH) method, and the microstructure evolution in the whole process of billets preparation was systematically investigated by optical microscopy, scanning electron microscopy, electron backscatter diffraction and transmission electron microscopy. The hot deformed feedstock was mainly composed of deformation structure with preferred orientations and a small number of dynamically recrystallized grains of FCC1 phase. In the semi-solid stage, the effect of temperature and soaking time on semi-solid microstructure was studied in the range of 1130-1250 degrees C and 5-120 min. The semi-solid microstructure was evaluated quantitatively. The average grain size and average shape factor increased with the increase of soaking time and isothermal temperature. After isothermal heat treatment, the segregation of Cu in FCC1 phase reduced to a certain extent. Semi-solid coarsening kinetics analysis showed that the alloy had low coarsening coefficients. When the temperatures were 1130 degrees C, 1175 degrees C, 1200 degrees C, 1225 degrees C and 1250 degrees C, the coarsening coefficients were 1.08 mu m(3)/s, 5.95 mu m(3)/s, 6.17 mu m(3)/s, 17.58 mu m(3)/s, 38.67 mu m(3)/s, respectively. A coarsening kinetic equation describing solid grain growth was established. During heating up, FCC1 and FCC2 phase recrystallized successively. At higher temperature, FCC2 phase was spheroidized to a certain extent. When temperature was raised to semisolid range, the grains of FCC2 phase coalesced, grew up and spheroidized and the preferred orientations basically disappeared. The types of semi-solid melting characteristics of HEAs were summarized in this paper. The semi-solid melting behavior of alloys is essentially affected by phase structure, phase number, phase volume content and composition. (C) 2022 Published by Elsevier Ltd on behalf of The editorial office of Journal of Materials Science & Technology.

Formation and evolution of metastable BCC phase during solidification of CoCrFeNi high-entropy alloy

Microstructural Evolution and Elevated-Temperature Strengthening Mechanism of Co-free FeCrMnNiV0.2Alx High-Entropy Alloys During Annealing

Effect of Co on phase stability and mechanical behavior of CoxCrFeNiMnAl0.3 high entropy alloys with micro/nano hierarchical structure

Microstructure Evolution and Formation Mechanism of CoCrCu1.2FeNi High Entropy Alloy During the Whole Process of Semi-Solid Billet Preparation

Synthesis of Ultrafine Dual-Phase Structure in CrFeCoNiAl0.6 High Entropy Alloy Via Solid-State Phase Transformation During Sub-Rapid Solidification

Spinodal Decomposition of B2‐phase and Formation of Cr‐Rich Nano‐precipitates in AlCoCrFeNi2.1 Eutectic High‐Entropy Alloy

Nanoscale phase separation in a fcc-based CoCrCuFeNiAl 0.5 high-entropy alloy

Origin identification and regulation of BCC precipitation in a CoCrFeNi high entropy alloy

Microstructure of and mechanical properties of an as-cast fine-grain dual-phase Fe-based high entropy alloy formed via solid-state phase transformation

Semi-solid thixotropic behavior and microstructure evolution of cold deformed CoCrCu 1.2 FeNi high-entropy alloy

Heterogeneous Microstructure and Tensile Properties of Fe50Mn30Co10Cr10 Metastable High-Entropy Alloy

Microstructure and Magnetic Properties of the FeCoNi(CuAl)0.8Ga0.06 High-Entropy Alloy During the Phase Transition

Microstructure Evolution and Mechanical Property of Directionally Solidified CoCrFeMnNi High Entropy Alloy

Comparative study of the microstructure and phase evolution of FeCoCrNiAl high-entropy alloy-matrix WC nanocomposite powders prepared by mechanical alloying

Microstructural evolution and phase selection during solidification of AlCrCuFeNi high entropy alloy

Microstructure evolution and mechanical properties of directionally solidified Ni36Co30Fe11Cr11Al8Nb4 high entropy alloy

Phase stability and strengthening behavior of as-annealed Co30Cr30Fe17Ni17Mo6 high entropy alloy at room and low temperatures

Microstructural Refinement and Anomalous Eutectic Structure Induced by Containerless Solidification for High-Entropy Fe–Co–Ni–Si–B Alloys

Effect of phase transformation of CoCrFeNiAl high-entropy alloy on mechanical properties of WC-CoCrFeNiAl composites

Formation of hypoeutectic structure and strengthening mechanism of Co4Cr1.5Fe1.5Ni5 high entropy alloy alloyed by Al

Effect of Co content on phase formation and mechanical properties of (AlCoCrFeNi) 100-x Co x high-entropy alloys