Abstract:Sintered gears manufactured through powder metallurgy technology contain residual porosity that can make them inadequate for high power supply. Crack propagation is significantly enhanced by both residual porosity and cyclical stresses involving the teeth. The use of densification processes can highly improve their performances, permitting the reduction of the residual porosity. Among the densification processes, the rolling assumes a key-role. The process permits the densification of the tooth flanks, the most stressed parts of the wheel. However, the performances of the rolled wheel depend on several process parameters, whose setup phase requires several efforts and many experiments. Finite element (FE) model can be a helpful tool, allowing a faster estimation of the process parameters, reducing waste and costs linked to the experimental tests. In this sense, FE modelling techniques discussed in literature only cover the simulation of spur gears densification process, since they consist of in-plane 2D finite elements. In this paper, different numerical modelling techniques, based on 2D finite elements, are proposed to simulate the densification process of spur gears and used to perform a tendency analysis to explore the effects of wheelbase reduction between the forming rollers on the material densification. Material densification appeared higher for reduced wheelbases, but an increasing cavity was observed at the tooth root as the wheelbases decreases. Moreover, a FE model based on 3D finite elements is proposed to reproduce numerically the rolling process of a helical gear. The accuracy of the 3D FE model was measured against the results provided by some experimental tests, herein discussed too. A good agreement between numerical and experimental results was observed.

On the Design and Simulation of Hybrid Metal-Composite Gears

A comparative analysis of adhesive bonding and interference fitting as joining technologies for hybrid metal-composite gear manufacturing

Composite Materials for Hybrid Aerospace Gears

Evaluating lightweight gear transmission error: a novel nonlinear finite element approach using direct constraint contact algorithm

Analysis of Composite Material Spur Gear Under Static Loading Condition

Structural design and dynamic analysis of a metal rubber composite gear pair

Design and Analysis of Composite Spur Gear

Optimum interface shape and vibration test for a new transmission helical gear composed of steel and aramid/phenol composite

Hybrid Dynamic Modeling and Analysis of High-Speed Thin-Rimmed Gears

Evaluation of Mechanical and Thermal Stresses in Polymer Gear Teeth through Simulation Approach

Finite Element Analysis of Composite Worm Gears

Design and analysis of aluminium matrix composite spur gear

Design and stress distribution analysis of composite spur gear

Analysis of the Contact Stresses of Spur Gears Manufactured by 3D Printing from Composite Materials

Contact stress analysis for a pair of aluminum matrix composite helical gear and steel worm

Design and development of epoxy hybrid composite gears for low-powered application

Computerized Developments in Design, Generation, Simulation of Meshing, and Stress Analysis of Gear Drives

Modeling and simulation of interface failure in metal-composite hybrids

Design and simulation of gear transmission system based on metamaterial

Dynamic design and transmission performance analysis based on CF/PEEK composite for short flexspline harmonic drive

Modelling approaches for surface densification process of sintered gear teeth