Abstract:The CIE color rendering (fidelity) index (CRI) has remained unchanged for over four decades. Most, if not all, of its components could be updated to more state-of-the-art methods. One of the most critical components of any color rendering (fidelity) metric is the test sample selection. This article therefore addresses the importance of uniform sampling of wavelength space to avoid selective optimizationthat is, taking advantage of the unequal contributions of different wavelength regions to the general color rendering scoreof light source spectral power distributions. It summarizes the development of a mathematical sample set with undistorted spectral sensitivity, the HL17 set. The set is used in a recently proposed update, the CRI2012 general color rendering index. To assess the impact of the spectrally uniform sample set on color fidelity scores, the CRI2012 index values for each of a set of 139 lamps were compared with those of the CIE CRI. In addition, the impact of updating the other components was investigated. A mean and maximum absolute difference of respectively 5.9 and 21.8 index units were found between the CRI2012 and CIE CRI, although the largest partrespectively 4.03 and 19.7 index unitswas shown to be the result of updating the color difference engine and the switch to the CIE 10 degrees observer. The analysis also indicated possible past spectral selective optimization of some warm-white tri-band fluorescent sources for high luminous efficacy of radiation (LER) and (just) sufficient CIE R-a values by taking advantage of the spectral nonuniformity of the CIE reflectance set. Adopting a spectrally uniform sample set in a color rendering metric therefore has important practical implications when designing light source spectra. Finally, possible updates and further improvements of the CRI2012 are briefly mentioned.

Maximum Spectral Luminous Efficacy of White Light

Spectral Optimization Simulation Of White Light Based On The Photopic Eye-Sensitivity Curve

Accelerated Life Test for High-Power White Led Based on Spectroradiometric Measurement

Luminous Efficacy of White LED in the Mesopic Vision State

Perceptual Responses to Led Illumination with Colour Rendering Indices of 85 and 97

An Approach to Calculate the Theoretical Luminous Efficacy of White LEDs at A Certain CCT

Spectral Optimization of White LED Based on Mesopic Luminance and Color Gamut Volume for Dim Lighting Conditions

Quantification of Trichromatic Light Sources to Achieve Tunable Photopic and Mesopic Luminous Efficacy of Radiation

Toward a Replacement of the CIE Color Rendering Index for White Light Sources

Physical Limitations of Phosphor layer thickness and concentration for White LEDs

Wavelength Dependence of Colorimetric Properties of Lighting Sources Based on Multi-Color LEDs

Whiteness Perception under Led Illumination

Circadian-effect Engineering of Solid-State Lighting Spectra for Beneficial and Tunable Lighting.

Chromaticity of White Sensation for Led Lighting

The CRI2012 Color Fidelity Index and Its Practical Application

Redefining artificial lighting through spectral engineering of light sources for well-being

Research of spectrum effects on color visual performance at mesopic condition

LED Light with Enhanced Color Saturation and Improved White Light Perception.

Optimization of Trichromatic Color Temperature Tunable White Light LEDs

Evaluation of Whiteness Indices

Realizing White LEDs with High Luminous Efficiency and High Color Rendering Index by Using Double Green Phosphors