Abstract:Ionic wind pumps have considerable potential for flow control, heat transfer, and drying applications due to their advantages of low energy consumption, compact structure, flexible design, and lack of moving parts. However, a high flow rate ionic wind pump with large cross-sectional for cooling high thermal power electronic devices requires further research. In this study, a two-stage ionic wind pump with needle-to-mesh electrodes was developed for cooling electronics. Experimental systems were established to test the flow and heat transfer characteristics. The effects of needle electrodes' arrangement, mesh electrodes' structure, needle tip-to-mesh gap, and stage distance on the output velocity and power consumption of ionic wind pumps were investigated. The influence of the arrangement of an ionic wind pump and heat sink on the cooling performance was also studied. Two groups of interactive mechanisms, interference between neighboring needles and needle density, the discharge effect and the resistance effect of mesh electrodes, affected the flow characteristics. A grid size with an optimal value of 4 mm was obtained by combining the discharge and resistance effects. As the needle tip-to-mesh gap increased, the velocity at the same applied voltage decreased but the velocity limit near the breakdown voltage increased. Counter discharge between the stages induced additional power consumption. As the stage distance increased, the breakdown shifted from between two stages to within each stage. The counter discharge disappeared as the stage distance increased to greater than 29 mm. At the ionic wind pump's optimum parameters, the output velocity of 3.91 m/s was achieved. And the cooling experiment indicated that the optimized ionic wind pump can reduced the surface temperature of a 200 W power heat source by more than 30 degrees C. The present study provides guidance for heat dissipation designs for maintenance-free electronics in remote areas.

Multiphysics simulation of corona discharge induced ionic wind

Numerical Simulation On Ionic Wind Heat Transfer In A Thermoelectric Cooling Sysytem

Nonlinear Interaction Between Ions and Multiple Electrostatic Waves

Experimental and Numerical Investigation of Corona Discharge Induced Flow on a Flat Plate

Analytical model of electro-hydrodynamic flow in corona discharge

A Hybrid Model to Predict Electron and Ion Distributions in Entire Interelectrode Space of a Negative Corona Discharge

Experimental Study of Heat Transfer Enhancement with Point-to-ring Corona Discharge

Review on the Recent Development of Corona Wind and Its Application in Heat Transfer Enhancement

A 2-D Axisymmetric Magneto-Hydrodynamic Model of a DC Arc Plasma Torch and Its Solution Methodology

Characterization of corona-induced ionic wind and spark channel formation using high-speed schlieren imaging

A review on recent advances and challenges of ionic wind produced by corona discharges with practical applications

Regulation-Controlling of Boundary Layer by Multi-Wire-To-Cylinder Negative Corona Discharge

Improve the secondary structure of the series ionic wind generator to regulate the flow distribution and its application in electronics cooling

Comparison of Initiation and Temporal Evolution of Positive and Negative Ionic Wind under Needle-to-Plate Electrode

Analysis of a Two-Stage Ionic Wind Pump with Multiple Needle-to-mesh Electrodes for Cooling Electronics

Electrohydrodynamic characteristics of a needle-to-ring positive corona discharges: self-consistent modeling and turbulence effects

Electrohydrodynamic and Heat Transfer Characteristics of a Planar Ionic Wind Generator with Flat Electrodes

An Efficient Numerical Technique for the Simulation of Charge Transport in Polymeric Dielectrics

3D PIC-MCC Simulation of Corona Discharge in Needle-Plate Electrode with External Circuit

Numerical Simulation of Corona Discharge Plasma Affecting the Surface Behavior of Polymer Insulators

Numerical Simulation of Assisted Electrode Discharges for Electromagnetic Wave Interactions