Abstract:In this paper, we describe a velocity interferometer system based entirely on single-mode fiber optics. This paper includes a description of principles used in developing the single-mode velocity interferometry system (SMV). The SMV design is based on polarization-insensitive components. Polarization adjusters are included to eliminate the effects of residual birefringence and polarization dependent losses in the interferometers. Characterization measurements and calibration methods needed for data analysis and a method of data analysis are described. Calibration is performed directly using tunable lasers. During development, we demonstrated its operation using exploding-foil bridge-wire fliers up to 200 m/s. In a final test, we demonstrated the SMV in a gas gun experiment up to 1.2 km/sec. As a basis for comparison in the gas gun experiment, we used another velocimetry technique that is also based on single-mode fiber optics: photonic Doppler velocimetry (PDV). For the gas gun experiment, we split the light returned from a single target spot and performed a direct comparison of the homodyne (SMV) and heterodyne (PDV) techniques concurrently. The two techniques had a negligible mean difference and a 1.5% standard deviation in the one-dimensional shock zone. Within one interferometer delay time after a sudden Doppler shift, a SMV unencumbered by multimode-fiber dispersion exhibits two color beats. These beats have the same period as PDV beats-this interference occurs between the "recently" shifted and "formerly unshifted" paths within the interferometer. We believe that recognizing this identity between homodyne and heterodyne beats is novel in the shock-physics field. SMV includes the conveniences of optical fiber, while removing the time resolution limitations associated with the multimode delivery fiber.

Weak Values Technique for Velocity Measurements

Ultrasensitive Velocity Estimation Via Cyclic Weak Measurement

Measuring small longitudinal phase shifts: weak measurements or standard interferometry?

Optical Acceleration Measurement Method with Large Non-ambiguity Range and High Resolution Via Synthetic Wavelength and Single Wavelength Superheterodyne Interferometry

Ultrasensitive Beam Deflection Measurement via Interferometric Weak Value Amplification

Modified Weak-Value-amplification Technique for Measuring a Mirror's Velocity Based on the Vernier Effect

Weak Value Amplification for Angular Velocity Measurements.

Difference Weak Measurement

Anomalous Amplification of a Homodyne signal via Almost-Balanced Weak Values

Amplification of rotation velocity using weak measurements in Sagnac's interferometer

Improving the precision of weak-value-amplification with two cascaded Michelson interferometers based on Vernier-effect

Enhancing interferometry using weak value amplification with real weak values

Weak-value-amplification metrology without spectral analysis

Enhanced on-chip frequency measurement using weak value amplification

Measuring ultrasmall time delays of light by joint weak measurements

Experimental simultaneous read out of the real and imaginary parts of the weak value

Enhanced on-chip phase measurement by inverse weak value amplification

The design of a new fiber optic sensor for measuring linear velocity with pico meter/second sensitivity based on Weak-value amplification

Velocity measurement of MEMS with temporal heterodyne microscopic speckle interferometry

Single-mode fiber, velocity interferometry

Measuring Small Longitudinal Phase Shifts via Weak Measurement Amplification