Vibration energy harvesting with printed P(VDF:TrFE) transducers to power condition monitoring sensors for industrial and manufacturing equipment

Asier Alvarez Rueda,Andreas Petritz,Philipp Schäffner,Markus Postl,Manfred Adler,Maria Belegratis,Jonas Groten,Barbara Stadlober
DOI: https://doi.org/10.1002/adem.202302140
IF: 3.6
2024-03-17
Advanced Engineering Materials
Abstract:We realize a vibration energy harvesting system based on fully printed piezoelectric transducers. The transducers have a butterfly‐like architecture based on two single optimized cantilevers with a resonance frequency tuned to 49.5 Hz and can be easily mounted to an industrial engine. By comparing single and multi‐stack configurations of the piezoelectric layers combined with full‐wave or voltage doubler rectifiers, the power transfer characteristics and impedance can be matched to the electrical requirements of the sensing circuitry. A single stack with 21 μm thickness results in the maximum power output of 14.4 μW at a vibration velocity of 11.5 mms‐1, typical for industrial engines. We use the system to power a wireless sensor node on a 1 kW rotary pump in normal operation. The system can harvest up to 138 mJ within 24 hours, sufficient for daily remote monitoring of the engine's vibration spectrum and temperature state. Our system is thus suitable as low‐cost, ecofriendly power source for industrial IoT applications. This article is protected by copyright. All rights reserved.
materials science, multidisciplinary
What problem does this paper attempt to address?