Abstract:Firefighters' or instructors' exposure to airborne chemicals during live-fire training may depend on fuels being burned, fuel orientation and participants' location within the structure. This study was designed to evaluate the impact of different control measures on exposure risk to combustion byproducts during fire dynamics training where fuel packages are mounted at or near the ceiling. These measures included substitution of training fuels (low density wood fiberboard, oriented strand board (OSB), pallets, particle board, plywood) and adoption of engineering controls such as changing the location of the instructor and students using the structure. Experiments were conducted for two different training durations: the typical six ventilation cycle (6-cycle) and a shorter three ventilation cycle (3-cycle) with a subset of training fuels. In Part A of this series, we characterized the fire dynamics within the structure, including the ability of each fuel to provide an environment that achieves the training objectives. Here, in Part B, airborne chemical concentrations are reported at the location where fire instructors would typically be operating. We hypothesized that utilizing a training fuel package with solid wood pallets would result in lower concentrations of airborne contaminants at the rear instructor location than wood-based sheet products containing additional resins and/or waxes. In the 6-cycle experiments (at the rear instructor location), OSB-fueled fires produced the highest median concentrations of benzene and 1,3 butadiene, plywood-fueled fires produced the highest total polycyclic aromatic hydrocarbon (PAH) concentrations, particle board-fueled fires produced the highest methyl isocyanate concentrations, and pallet-fueled fires produced the highest hydrogen chloride concentrations. All fuels other than particle board produced similarly high levels of formaldehyde at the rear instructor location. The OSB fuel package created the most consistent fire dynamics over 6-cycles, while fiberboard resulted in consistent fire dynamics only for the first three cycles. In the follow-on 3-cycle experiment, PAH, benzene, and aldehyde concentrations were similar for the OSB and fiberboard-fueled fires. Air sampling did not identify any clear differences between training fires from burning solid wood pallets and those that incorporate wood-based sheet products for this commonly employed fuel arrangement with fuels mounted high in the compartment. However, it was found that exposure can be reduced by moving firefighters and instructors lower in the compartment and/or by moving the instructor in charge of ventilation from the rear of the structure (where highest concentrations were consistently measured) to an outside position.

Impact of supply and exhaust ventilation system on gas concentrations in a compartment during thermal decomposition and combustion of materials

Experimental and Analytical Studies of the Toxicity of Combustion Products, Detection and Extinguishing of Fires in the Pressurized Pressure Chambers in Environments Enriched with Oxygen and at the Alevated Pressure

Reduction of response time of fire detection and containment systems in compartments

Effects of ventilation conditions and procedures during a fire in a reduced-scale room

Influence of Compartment Fire Behavior at Ignition and Combustion Development Stages on the Operation of Fire Detectors

Influence of Ventilation on the Release of CO_2 and CO in Fire Smoke

Impact of air supply cessation time on thermal characteristics in coal mine dead-end roadway fires: An experimental study

Comprehensive laboratory study on smoke gases during the thermal oxidative decomposition of forest and vegetation fuels

Composition of the Gas-Air Mixture in the Containment and Suppression of Forest Fires with Promising Extinguishing Agents

Exposure Risks and Potential Control Measures for a Fire Behavior Lab Training Structure: Part B. Chemical Gas Concentrations

Full-scale Experiment on Smoke Propagation in Metro Station Tunnel Fire under Opening the Platform Screen Doors

Experimental Study on Cross-ventilation Compartment Fire in the Wind Environment

Wood-burning processes in variable oxygen atmospheres: Thermolysis, fire, and smoke release behavior

Experimental Investigation of Combustion Characteristics under Different Ventilation Conditions in A Compartment Connected to A Stairwell

Analysis of the Operation of Smoke Exhaust Ventilation in the Metro’s Technological Corridor Based on Numerical Simulation of Selected Locations of Fire

Experimental study of fire growth and ejected plume in a cross-ventilation compartment under wind condition

Using the Burning of Polymer Compounds to Determine the Applicability of the Acoustic Method in Fire Extinguishing

Impact of Fuel Type on Fire Dynamics in Mechanically Ventilated Compartment as a Consequence of Closing Inlet Vent

Wind Effects on Smoke Motion and Temperature of Ventilation-Controlled Fire in a Two-Vent Compartment

Wind Tunnel Tests on Compartment Fires with Crossflow Ventilation

Study on Combustion Characteristics and Evacuation during Intake Airway Fire in Coal Face under Different Ventilation Conditions