Abstract:The use of slip-critical connections is very common in the design of critical steel structures and is seen as an effective way to transfer the force in conditions of dynamic loading. The limit state of the connection occurs when the calculated shear stress is reached, which depends on the friction coefficient of the contact planes and the value of the clamping force, equal to the bolt tension stress. In order to ensure the necessary bolt tensioning force, it is necessary to know the bolt tightening coefficient, because according to the current understanding of the slip-critical connection performance, the designed functioning of the bolt connection is ensured when the bolt tensioning force arising at the necessary torque value is achieved. Otherwise, the actual work of the connection will be different from the calculated, because only a given tension force provides the estimated bearing capacity of the bolted connection with friction planes. This article focuses on tensile testing of a bolt and determining the tightening factor of a bolt made of high-strength10.9 M14 steel. The tightening factor is determined with strain gauges by measuring the relative strain of the bolt when the nut is tightened. This method requires specialized equipment and a test bench and can be used in the study of bolt performance in the absence of a certificate or the need to verify or clarify the available data. The results show that the proposed method can provide a stable determination of the coefficient value. The examined bolts were made according to the German standard DIN931, strength 10.9 size M14x220, nuts according to the German standard DIN934, strength 10 size M14. An Instron 1000HDX tensile testing machine was used to plot the performance of the bolt steel. Nut tension control was determined with the use of NOGRAU NTW24-034R torque wrench, and bolt elongation control with FLA 5-11 strain gauges and National Instruments data acquisition system. On the basis of the conducted research, a method for determining the tightening factor of high-strength bolts has been tested and proposed. The proposed method of determining the tightening factor of a high-strength bolt can be used in research work and allows to determine the coefficient in the absence of an appropriate certificate or the need to clarify (verify) the stated value of the coefficient.

Analysis of Errors in Bolt Joint Tightening

Effect of Interference Fit Size on Local Stress in Single Lap Bolted Joints

Mechanical Behavior of Loose High-Strength Bolted Connections with Thin Sheet Steels

FEM-based Multi-field Coupling Stress Analyses of the Cylinder-bolts System in a Gas Turbine Power Plant

Stress Analysis of Bolted Joints Part II. Contact and Slip Analysis of a Four Bolt Joint

The Tightening and Untightening Modeling and Simulation of Bolted Joints

Tightening performance analysis of bolted connection considering non-parallel contact

Optimal tightening process of bolted joints

A Review of Bolt Tightening Force Measurement and Loosening Detection

Experimental determination of the tightening coefficient of bolts according to the din standard

Degradation and failure analysis of bolted joints under transverse loading

Variables Affecting the Assembly Bolt Stress Developed During Manual Tightening

Finite element analysis of bolted joints under torsional loads

Analytical Modeling of Self-Loosening of Bolted Joints Subjected to Transverse Loading

Analyses of Tightening Characteristics and Cyclic Stress Amplitude of Studs and Tap Bolts

Strength Analysis of Bolt Joints for an Open Frame Structure

A Review Paper on Looseness Detection Methods in Bolted Structures

Experimental investigation on stress state and deformation in bolts through tightening of perfect flange connections

Analysis of the Tightening Process and the Cyclic Stress Amplitude of Studs and Tap Bolts

Effect of Parameters on Local Stress Field in Single-Lap Bolted Joints with the Interference Fit