Abstract:Survival of the production target in successive experiments (with a repetition rate of 1 Hz) over an extended period of time is one of the key problems encountered in designing the Super-FRS (Superconducting Fragment Separator) at the future Facility for Antiprotons and Ion Research (FAIR). Because of the difficulties involved in construction of a liquid jet metal target, it is highly desirable to employ a solid production target at the Super-FRS. However, with the high beam intensities that will be available at the FAIR, the production target may be destroyed in a single experiment due to high specific energy deposition by the beam in the target material. The level of specific energy deposition can be reduced to an acceptable value by increasing the beam focal spot area. However, the spot size is limited by requirements of achieving good isotope resolution and sufficient transmission of the secondary beam through the system. The resolving power of the fragment separator is inversely proportional to the X-dimension of the focal spot whereas the transmission depends on Y-dimension only. It has been previously shown [Tahir et al., 2005c] that an elliptic focal spot with appropriate dimensions, will fulfill the above two conditions simultaneously and will also have a large enough area to reduce the specific energy deposition to an acceptable level for certain beam intensities of interest. In this paper we present numerical simulations of thermodynamic and hydrodynamic behavior of a solid graphite target that is irradiated by 1 GeV/u uranium beam in the intensity range of 10(10)-10(11) ions per bunch with a bunch length = 50 ns, These simulations have been carried out using a three-dimensional computer code, PIC3D, that includes elastic-plastic effects. This theoretical work has shown that up to a beam intensity of 10(11) ions/bunch, one can employ a solid target while for higher intensities the target will be destroyed due to thermal stresses induced by the beam. It has also been found that a circular focal spot leads to minimum thermal stresses as it generates minimum pressure gradients compared to an elliptic focal spot, for the same specific energy deposition. Moreover, the stress level increases with an increase in the ellipticity of the focal spot. It is therefore recommended that one should use a circular focal spot for lower intensities provided that the criteria for isotope resolution and transmission are fulfilled.

High-power targets: experience and R&D for 2 MW

Novel materials for next-generation accelerator target facilities

Multiphysics Simulations of Thermal Shock Testing of Nanofibrous High Power Targets

Targetry Challenges at Megawatt Proton Accelerator Facilities

Studies of material properties under irradiation at BNL Linear Isotope Producer (BLIP)

High-power Production Targets for the Super-FRS Using a Fast Extraction Scheme

Neutrino yield and neutron shielding calculations for a high-power target installed in an underground setting

Novel Approaches to High-Power Proton Beams

High Energy Density Physics Problems Related to Liquid Jet Lithium Target for Super-Frs Fast Extraction Scheme

High Energy Density and Beam Induced Stress Related Issues in Solid Graphite Super-Frs Fast Extraction Targets

Design of the third-generation lead-based neutron spallation target for the neutron time-of-flight facility at CERN

Design of a high power production target for the Beam Dump Facility at CERN

Target, magnetic horn and safety studies for the CERN to Frejus Super Beam

Design of the LBNF Beamline Target Station

Development of a Neutron Generating Target for Compact Neutron Sources Using Low Energy Proton Beams

Future Accelerator-Based Neutrino Beams

Calculations of High-Power Production Target and Beamdump for the Gsi Future Super-Frs for A Fast Extraction Scheme at the Fair Facility

Generation of Warm Dense Matter and Strongly Coupled Plasmas Using the High Radiation on Materials Facility at the CERN Super Proton Synchrotron

A high-intensity, low-energy heavy ion source for a neutron target proof-of-principle experiment at LANSCE

Secondary beams at high-intensity electron accelerator facilities

Development of a high current electron beam facility for compact accelerator neutron source target thermal tests