Full Band Gap and Defects States in Solid-in-Solid Three Dimensional Phononic Crystals

Ke Sun,Z. Yang

DOI: https://doi.org/10.48550/arXiv.1202.1137

2012-02-06

Abstract:A full band gap of the longitudinal mode of elastic waves centered near 2.8 MHz with a width of ~ 1 MHz has been observed in the phononic crystals made of body centered tetragonal tungsten carbide spheres imbedded in aluminum matrix. Two defects states in the band gap due to a 7-sphere defect cluster with silicon nitride spheres have also been observed. Transmitted pressure field pattern clearly shows that at the defect state frequencies the ultrasonic waves transmitted through the doped crystal are emitted from the defect cluster.

Materials Science

What problem does this paper attempt to address?

The main problems that this paper attempts to solve are the realization and verification of the full band gap and defect states in three - dimensional phononic crystals (3D PCs). Specifically:

1. **Realization of the full band gap**: The paper shows that a solid - solid three - dimensional phononic crystal constructed by embedding tungsten carbide (WC) spheres in an aluminum (Al) matrix realizes a complete band gap for the longitudinal mode of elastic waves. This band gap is located near about 2.8 MHz and has a width of about 1 MHz.

2. **Introduction of defect states**: In order to study the wave localization phenomenon, the author introduced a defect cluster composed of silicon nitride (Si₃N₄) spheres in the phononic crystal. The experimental results show that two defect states were observed within the band gap, located at 2.83 MHz and 3.07 MHz respectively. The existence of these defect states indicates that waves can be localized at specific frequencies, similar to the situation in photonic crystals.

### Specific problems and solutions

- **Material selection**: In order to reduce absorption losses in ultrasonic applications in the range of several megahertz, aluminum was selected as the matrix material because aluminum has almost no internal loss in this frequency range.

- **Experimental design**: The existence of the band gap was verified by measuring the transmission spectrum in water through the pulsed ultrasonic technique, and the defect states were observed by introducing defect clusters. The experimental emission characteristics of the defect states were further confirmed through the spatial distribution map.

### Main findings

- **Band - gap characteristics**: A clear band gap from 2.2 MHz to 3.3 MHz was observed in different crystal orientations ([110], [001] and [110]), with a relative bandwidth of about 40%.

- **Defect - state characteristics**: The introduced defect cluster led to two obvious defect states, with quality factors of 71 and 307 respectively, indicating that these states have high resonance quality.

### Conclusion

This research successfully realized the full band gap in a solid - solid three - dimensional phononic crystal and experimentally observed the defect states within the band gap for the first time. These results provide an important theoretical and experimental basis for future applications in the field of high - frequency ultrasonics.

### Related formulas

- **Group velocity calculation**:
\[
v_g=\frac{d\omega}{dk} = L\cdot\frac{d\omega}{d\phi}
\]
where \( \omega \) is the angular frequency, \( k \) is the wave vector, \( L \) is the thickness of the PC, and \( \phi \) is the phase.

- **Quality factor**:
\[
Q = \frac{f_0}{\Delta f}
\]
where \( f_0 \) is the central frequency and \( \Delta f \) is the full width at half maximum (FWHM).