Abstract:The CMS tracker consists of two tracking systems utilizing semiconductor technology: the inner pixel and the outer strip detectors. The tracker detectors occupy the volume around the beam interaction region between 3 cm and 110 cm in radius and up to 280 cm along the beam axis. The pixel detector consists of 124 million pixels, corresponding to about 2 m$^{2}$ total area. It plays a vital role in the seeding of the track reconstruction algorithms and in the reconstruction of primary interactions and secondary decay vertices. It is surrounded by the strip tracker with 10 million read-out channels, corresponding to 200 m$^{2}$ total area. The tracker is operated in a high-occupancy and high-radiation environment established by particle collisions in the LHC. The performance of the silicon strip detector continues to be of high quality. The pixel detector that has been used in Run 1 and in the first half of Run 2 was, however, replaced with the so-called Phase-1 Upgrade detector. The new system is better suited to match the increased instantaneous luminosity the LHC would reach before 2023. It was built to operate at an instantaneous luminosity of around 2$\times$10$^{34}$cm$^{-2}$s$^{-1}$. The detector's new layout has an additional inner layer with respect to the previous one; it allows for more efficient tracking with smaller fake rate at higher event pile-up. The paper focuses on the first results obtained during the commissioning of the new detector. It also includes challenges faced during the first data taking to reach the optimal measurement efficiency. Details will be given on the performance at high occupancy with respect to observables such as data-rate, hit reconstruction efficiency, and resolution.

CMS Pixel Detector Upgrade

A new CMS pixel detector for the LHC luminosity upgrade

The CMS Phase-1 Pixel Detector Upgrade

Status of the CMS Phase I Pixel Detector Upgrade

Level-1 pixel based tracking trigger algorithm for LHC upgrade

Evaluation of Planar Silicon Pixel Sensors with the RD53A Readout Chip for the Phase-2 Upgrade of the CMS Inner Tracker

Performance verification of the CMS Phase-1 Upgrade Pixel detector

3D silicon pixel sensors for the CMS experiment tracker upgrade

Pixel detector R&D for the Compact Linear Collider

Mighty Tracker -- Performance Studies of the MightyPix for LHCb

Upgrade of the ALICE Inner Tracking System

Pixel front-end development in 65 nm CMOS technology

MightyPix at the LHCb Mighty Tracker — verification of an HV-CMOS pixel chip's digital readout

The Pixel Luminosity Telescope: A detector for luminosity measurement at CMS using silicon pixel sensors

R&D for the CLIC Vertex and Tracking detectors

CMS detector: Run 3 status and plans for Phase-2

Operation and performance of the CMS tracker

A Full Functional Monolithic Active Pixel Sensor Prototype for the CEPC Vertex Detector

The upgrade of the CMS electromagnetic calorimeter for HL-LHC

Evaluation of HPK $n^+$-$p$ planar pixel sensors for the CMS Phase-2 upgrade

Design and performance of the silicon sensors for the CMS barrel pixel detector