Abstract:When poking a thin shell-like structure, like a plastic water bottle, experience shows that an initial axisymmetric dimple forms around the indentation point. The ridge of this dimple, with increasing indentation, eventually buckles into a polygonal shape. The polygon order generally continues to increase with further indentation. In the case of spherical shells, both the underlying axisymmetric deformation and the buckling evolution have been studied in detail. However, little is known about the behaviour of general geometries. In this work we describe the geometrical and mechanical features of the axisymmetric ridge that forms in indented general shells of revolution with non-negative Gaussian curvature and the conditions for circumferential buckling of this ridge. We show that, under the assumption of `mirror buckling' a single unified description of this ridge can be written if the problem is non-dimensionalised using the local slope of the undeformed shell mid-profile at the ridge radial location. In dimensional form the ridge properties evolve in quite different ways for different mid-profiles. Focusing on the indentation of shallow shells of revolution with constant Gaussian curvature, we use our theoretical framework to study the properties of the ridge at the circumferential buckling threshold and evaluate the validity of the mirror buckling assumption against a linear stability analysis on the shallow shell equations, showing very good agreement. Our results highlight that circumferential buckling in indented thin shells is controlled by a complex interplay between the geometry and the stress state in the ridge. The results of our study will provide greater insight into the mechanics of thin shells. This could enable indentation to be used to measure the mechanical properties of a wide range of shell geometries or used to design shells with specific mechanical behaviours.

Rim curvature anomaly in thin conical sheets revisited

Drained Analyses of Cylindrical Cavity Expansion in Sand Incorporating a Bounding-Surface Model with State-Dependent Dilatancy

Wrinkling and developable cones in centrally confined sheets

Lifting, Loading, and Buckling in Conical Shells

Geometric dependence of curvature-induced rigidity

A unified geometric framework for axisymmetric thin sheet buckling

Torsional Buckling Analysis of Composite Anisogrid Conical Shells: Theoretical Approach and Numerical Validation

Truncated cones from indenting a clamped disk

Cross-sections of doubly curved sheets as confined elastica

A sheet on deformable sphere: "wrinklogami" patterns suppress curvature-induced delamination

Wrinkling of a thin circular sheet bonded to a spherical substrate

Contribution to mathematical modeling of cup drawing: the upper-bound analysis for inward pull (case II) in ring forming

Geometric frustration of hard-disk packings on cones

Initial Perturbation of the Mean Curvature Flow for Asymptotical Conical Limit Shrinker

Non-affine bending mode of thin cylindrical tubes

A New Version of Huisken's Convergence Theorem for Mean Curvature Flow in Spheres

How two-dimensional bending can extraordinarily stiffen thin sheets

A capillary problem for spacelike mean curvature flow in a cone of Minkowski space

Length-constrained, length-penalised and free elastic flows of planar curves inside cones

Discontinuity of curvature on axisymmetric Willmore surfaces

Axisymmetric Ridges and Circumferential Buckling of Indented Shells of Revolution