Abstract:The dual-cylinder opposed linear compressor (DOLC) contains a couple of symmetrical gas loads on the two sides of the movement components. Because the gas loads are symmetrical, the balanced position of movement components will not be offset by gas force during the operating process, and piston displacement can be detected and controlled more easily. Based on the kinetics and thermodynamics theory, the non-linear gas load of the DOLC was linearized by the Fourier method. The relationship between the supply voltage and displacement is presented. Through air compression experiments, the operation features of the DOLC with different syntonic spring groups were analyzed. The performance of the DOLC was considerably affected by work conditions and the stiffness of syntonic spring groups; the closer the work condition was to the sympathetic vibration, the higher the observed efficiency of the DOLC. A jump, hysteresis, and an unstable phenomenon in the process of voltage regulation occurred around sympathetic vibration conditions. In the process of increasing voltage on a certain discharge pressure condition, the displacement jump phenomenon occurred when the intrinsic frequency approacheds power frequency, causing the discharge pressure to drop synchronously. In the process of decreasing voltage on the lower discharge pressure condition, the displacement shrink phenomenon occurred when the intrinsic frequency approached power frequency. Because sympathetic vibration conditions changed with discharge pressures, a hysteresis district existed between the displacement jump point and shrink point. The DOLC worked unstably on the hysteresis district because the discharge pressure fluctuated between the two values. To make the DOLC work stably on higher efficiency, the intrinsic frequency should be configured to a slightly larger value than the power frequency by setting the syntonic spring groups and the mass of movement components to the ratings on the work conditions. Controlling the power frequency after is needed to adhere to the intrinsic frequency of the variable work conditions.

Study of the moving offset characteristics of multi-loop moving coil linear compressor

Experimental study of DC excitation effect on the performance of moving coil linear compressor

Design and Test on Moving-Magnet Linear Compressor

Performance Testing of Linear Compressors with Rc Approach

Studies on Moving Coil Linear Compressor Used for Refrigerator

Simulation of Dynamic Characteristics of Moving Magnet Linear Compressor for Refrigerator

Study on Flow Field in Capacity Regulating Actuator for Reciprocating Compressor

Dynamic Characteristics of Moving-Magnet Linear Compressor Based on Finite Element Method

Valve Dynamic and Thermal Cycle Model in Stepless Capacity Regulation for Reciprocating Compressor

Theoretical and Experimental Investigations on a 12 Kw Oxford-type Dual-Opposed Moving-Coil Linear Compressor

Dynamic behavior analysis of a moving coil oil-free linear compressor in refrigeration system

Experimental Investigation and Performance Analysis of a Dual-Cylinder Opposed Linear Compressor

Performance testing with RC load approach in linear compressors

Theoretical Modeling and Experimental Verification of the Motor Design for a 500 G Micro Moving-Coil Linear Compressor Operating at 90–140 Hz

Design of A Valved Moving Magnet Type Linear Compressor for A Joule-Thomson Cryocooler

Acoustic Impedance Characteristics of Linear Compressors

Research on Linear Motor for Linear Compressor

Self-Sencing Control Research on a Linear Compressor

Investigation of clearance leakage and piston offset of Joule-Thomson linear compressors at high pressure ratios

Performance of a linear refrigeration compressor with small clearance volume

Experimental investigation and numerical simulation on the hysteresis zone of a variable displacement wobble plate compressor