Abstract:Purpose: Computational fluid dynamics (CFD) and 4D-flow magnetic resonance imaging (MRI) are synergically used for the simulation and the analysis of the flow in a patient-specific geometry of a healthy thoracic aorta. Methods: CFD simulations are carried out through the open-source code SimVascular. The MRI data are used, first, to provide patient-specific boundary conditions. In particular, the experimentally acquired flow rate waveform is imposed at the inlet, while at the outlets the RCR parameters of the Windkessel model are tuned in order to match the experimentally measured fractions of flow rate exiting each domain outlet during an entire cardiac cycle. Then, the MRI data are used to validate the results of the hemodynamic simulations. As expected, with a rigid-wall model the computed flow rate waveforms at the outlets do not show the time lag respect to the inlet waveform conversely found in MRI data. We therefore evaluate the effect of wall compliance by using a linear elastic model with homogeneous and isotropic properties and changing the value of the Young's modulus. A stochastic analysis based on the polynomial chaos approach is adopted, which allows continuous response surfaces to be obtained in the parameter space starting from a few deterministic simulations. Results: The flow rate waveform can be accurately reproduced by the compliant simulations in the ascending aorta; on the other hand, in the aortic arch and in the descending aorta, the experimental time delay can be matched with low values of the Young's modulus, close to the average value estimated from experiments. However, by decreasing the Young's modulus the underestimation of the peak flow rate becomes more significant. As for the velocity maps, we found a generally good qualitative agreement of simulations with MRI data. The main difference is that the simulations overestimate the extent of reverse flow regions or predict reverse flow when it is absent in the experimental data. Finally, a significant sensitivity to wall compliance of instantaneous shear stresses during large part of the cardiac cycle period is observed; the variability of the time-averaged wall shear stresses remains however very low. Conclusions: In summary, a successful integration of hemodynamic simulations and of MRI data for a patient-specific simulation has been shown. The wall compliance seems to have a significant impact on the numerical predictions; a larger wall elasticity generally improves the agreement with experimental data.

Numerical study of blood flow in an anatomically realistic aorto-iliac bifurcation generated from MRI data

Non-invasive Evaluation of Fluid Dynamic of Aortoiliac Atherosclerotic Disease: Impact of Bifurcation Angle and Different Stent Configurations

Experimental Study on Hemodynamics of an End-to-side Anastomosis

NUMERICAL SIMULATION OF TRANSIENT BLOOD FLOW THROUGH THE LEFT CORONARY ARTERY WITH VARYING DEGREES OF BIFURCATION ANGLES

Numerical Simulation of Blood Flow in Aortoiliac Bifurcation with Increasing Degree of Stenosis

Helical Flow As a New Determinant of Coronary Plaque Vulnerability: a Glimpse into the Future

Numerical study on the effect of steady axial flow development in the human aorta on local shear stresses in abdominal aortic branches

Computational fluid dynamic simulation of human carotid artery bifurcation based on anatomy and volumetric blood flow rate measured with magnetic resonance imaging

Reproducibility Study of Magnetic Resonance Image-Based Computational Fluid Dynamics Prediction of Carotid Bifurcation Flow

MRI measurement of wall shear stress vectors in bifurcation models and comparison with CFD predictions

Numerical simulation of two-phase non-Newtonian blood flow with fluid-structure interaction in aortic dissection

Three-dimensional numerical simulation of hemodynamics in human aortic arch

Numerical Study of Bifurcated Blood Flow in Three Different Blood Viscosity Models

Numerical simulation of flow behavior in basilar bifurcation computed tomography angiography

Validation of Numerical Simulations of Thoracic Aorta Hemodynamics: Comparison with In Vivo Measurements and Stochastic Sensitivity Analysis

Image-Based Numerical Investigation in an Impending Abdominal Aneurysm Rupture

Numerical simulation of blood flow in image-based cerebral aneurysms

Numerical Analysis of the Non-Newtonian Blood Flow in the Non-Planar Artery with Bifurcation

4D Flow MRI-Based Computational Analysis of Blood Flow in Patient-Specific Aortic Dissection.