Abstract:A new method for calculating rolling resistance is developed. This method includes a simplified structural model of a wheel in the form of a rigid cylinder with a thin viscoelastic rim. The wheel loading mode is considered in the absence of shearing (horizontal) force. In the entire contact area, it is assumed that the wheel is gripped with a non-deformable support surface. Deformation of the viscoelastic layer is analyzed on the basis of the Winkle model. In contrast to the previously known ones, the proposed method implies a description of the symmetry breaking in the distribution of contact pressure when a small torque is applied to the wheel, not exceeding the rolling resistance at rest. Contact pressure diagrams are obtained at different values of the torque applied to the wheel. It is shown that as the torque increases, the maximum value of the contact pressure increases, and the position of this maximum shifts in the direction of possible rolling. From the condition of violating the contact area dimensions at the beginning of rolling, an analytical expression is derived for the moment of rolling resistance at rest. The calculated dependence of this moment on the wheel draft is compared with known experimental data. When describing stationary free rolling, the asymmetry of the contact pressure corresponding to the beginning of rolling and the loss of energy during deformation of the viscoelastic material of the wheel rim are taken into account. The dependences of the coefficient of rolling resistance and wheel draft on the speed of the wheel center of mass at a fixed value of the vertical load are obtained. It is shown that taking into account the initial asymmetry of the contact pressure leads to a more intensive increase in the calculated estimates of the resistance coefficient and a less marked decrease in the wheel draft with an increase in rolling speed.

Interactions of a Deformable Wheel with a Deformable Support Surface

Wheel rolling on deformable ground with slippage

Numerical analysis of the dynamic interaction between a non-pneumatic mechanical elastic wheel and soil containing an obstacle

Analysis of Contact Deformations in Support Systems Using Roller Prisms

Simulation of the Wheel-Surface Interaction Dynamics for All-Terrain Vehicles

Finite Element Modeling of Interaction Between Non-Pneumatic Mechanical Elastic Wheel and Soil

CALCULATION OF THE COEFFICIENT OF FREE ROLLING RESISTANCE FOR THE WHEEL WITH DEFORMABLE RIM

Wear modelling in wheel–rail contact problems based on energy dissipation

A comprehensive wheel-terrain contact model for planetary exploration rover design optimization

Method for calculating the track depth after successive wheel runs on deformable soil

POSSIBILITIES FOR OPTIMAL DESIGN OF A CAR TIRE BASED ON A CRITERION OF SPATIAL STRENGTH BALANCE

Calculation of the Effective Normal Stiffness of a Deformable Wheel with a Tilted Rotation Axis

New Tribological Aspects in the Micro-Areas of the Symmetric Rolling-Sliding Contact

Graphic analytical optimization of design and operating parameters of tires for drive wheels of agricultural machinery

Simulation of Steady-State Rolling Non-Pneumatic Mechanical Elastic Wheel Using Finite Element Method

Analyzing the interaction mechanism between tire side-slip angle and sidewall flexible deformation using enhanced digital image correlation

Interaction of In-wheel Permanent Magnet Synchronous Motor with Tire Dynamics

Three-dimensional contact surface modeling and stress analysis of interference fit based on cylindricity error

The Finite Element Analysis for Supporting Wheel Deflection's Contact of Large-scale Rotary Kiln With Multi-supporting

Equivalent Vertical Stiffness Design of Modular Deformable Wheel

Improving the performance of finite element simulations on the wheel-rail interaction by using a coupling strategy