Abstract:Purpose: The appearance of x-ray luminescence computed tomography (XLCT) opens new possibilities to perform molecular imaging by x ray. In the previous XLCT system, the sample was irradiated by a sequence of narrow x-ray beams and the x-ray luminescence was measured by a highly sensitive charge coupled device (CCD) camera. This resulted in a relatively long sampling time and relatively low utilization of the x-ray beam. In this paper, a novel cone beam x-ray luminescence computed tomography strategy is proposed, which can fully utilize the x-ray dose and shorten the scanning time. The imaging model and reconstruction method are described. The validity of the imaging strategy has been studied in this paper.Methods: In the cone beam XLCT system, the cone beam x ray was adopted to illuminate the sample and a highly sensitive CCD camera was utilized to acquire luminescent photons emitted from the sample. Photons scattering in biological tissues makes it an ill-posed problem to reconstruct the 3D distribution of the x-ray luminescent sample in the cone beam XLCT. In order to overcome this issue, the authors used the diffusion approximation model to describe the photon propagation in tissues, and employed the sparse regularization method for reconstruction. An incomplete variables truncated conjugate gradient method and permissible region strategy were used for reconstruction. Meanwhile, traditional x-ray CT imaging could also be performed in this system. The x-ray attenuation effect has been considered in their imaging model, which is helpful in improving the reconstruction accuracy.Results: First, simulation experiments with cylinder phantoms were carried out to illustrate the validity of the proposed compensated method. The experimental results showed that the location error of the compensated algorithm was smaller than that of the uncompensated method. The permissible region strategy was applied and reduced the reconstruction error to less than 2 mm. The robustness and stability were then evaluated from different view numbers, different regularization parameters, different measurement noise levels, and optical parameters mismatch. The reconstruction results showed that the settings had a small effect on the reconstruction. The nonhomogeneous phantom simulation was also carried out to simulate a more complex experimental situation and evaluated their proposed method. Second, the physical cylinder phantom experiments further showed similar results in their prototype XLCT system. With the discussion of the above experiments, it was shown that the proposed method is feasible to the general case and actual experiments.Conclusions: Utilizing numerical simulation and physical experiments, the authors demonstrated the validity of the new cone beam XLCT method. Furthermore, compared with the previous narrow beam XLCT, the cone beam XLCT could more fully utilize the x-ray dose and the scanning time would be shortened greatly. The study of both simulation experiments and physical phantom experiments indicated that the proposed method was feasible to the general case and actual experiments. (C) 2013 American Association of Physicists in Medicine.

Current Status and Future Prospects of the Linear and Non-Linear Attenuation Coefficients of Cancer Cells, Tissues and Tumors by Synchrotron X-Ray Radiation (SXR) Computed Tomography

High-resolution computed tomography with scattered x-ray radiation and a single pixel detector

Optimization of Image Quality and Acquisition Time for Lab-Based X-ray Microtomography Using an Iterative Reconstruction Algorithm

A new scheme for real-time high-contrast imaging in lung cancer radiotherapy: a proof-of-concept study

Investigation Of Low-Contrast Tumor Detection In Algorithm-Enabled Low-Dose Cbct

Synchrotron X-ray Radiation (SXR) in Medical Imaging: Current Status and Future Prospects

Current status and new horizons in Monte Carlo simulation of X-ray CT scanners

Stationary Computed Tomography for Space and other Resource-constrained Environments

Efficient Low Dose X-ray CT Reconstruction through Sparsity-Based MAP Modeling

Energy-angle Correlation Correction Algorithm for Monochromatic Computed Tomography Based on Thomson Scattering X-ray Source

Non-Linear 3d Reconstruction For Compressive X-Ray Tomosynthesis

Simultaneous Fluorescence and Compton Scattering Computed Tomography Based on Linear Polarization X-ray

Photon counting and color X-ray imaging in standard CIS technology

Dual-energy CT Imaging Method Using Synchrotron Radiation

Laboratory x-ray nano-computed tomography for biomedical research

An Experimental Study of Dual-Energy CT Imaging Using Synchrotron Radiation

Cone Beam X-Ray Luminescence Computed Tomography: a Feasibility Study.

Instant Coded X-ray Computed Tomography Via Nonlinear Reconstruction

High-sensitivity and spatial resolution benchtop cone beam XFCT imaging system with pixelated photon counting detectors using enhanced multipixel events correction method

Non-destructive X-ray tomography of brain tissue ultrastructure