Abstract:Present study determines conditions for titanium magnetite concentrate processing with fairly complete titanium conversion to the slag and iron and vanadium separation in the hot metal. It is quite difficult to process titanium magnetite concentrate in the blast furnaces due to low fusibility of charge and direct electrical melting which cause process instability. Present work is devoted to development of concentrate double stage smelting process with little soda additions, including solid-phase recovery at the first stage using specific coke as a reductant, avoiding concentrate oxidation and including its preliminary thermooxidation. Mix charge made of concentrate, soda and specific coke was granulated in water, dried at 130°C, pellets were placed in graphite crucible, and later on it was set up in the centre of the furnace in alundum crucible. Temperature regimen was fixed under following parameters: temperature at the first stage was 1250°C; soaking time was 50 min; temperature at the second stage was 1500 - 1650°C; soaking time was 35 min. It is established that little soda additive (estimated 3-4% Na2O) to the charge of titanium magnetite concentrate recovery smelting behaves as a coagulant during briquetting, as a catalyst in course of solid-phase recovery, as an inhibitor of DRI briquettes secondary oxidation as slag thinner during smelting. In course of titanium magnetite concentrate reduction smelting process, soda interacts to SiO2, AhO3, TiO2 oxides forming sodium silicates and titanates. Double-stage technology of titanium magnetite concentrate reduction smelting was used, both with soda addition, and without oxidation and preliminary iron oxidation of titanium magnetite concentrates till hematite was developed. Optimal process parameters were determined. Following parameters were obtained: hot metal yield was ~⃒55% of concentrate weight, slag yield - 23.3-25.8%, carbon-free slag content, wt.%: Fe=1.0-1.6; TiO2=62.7-61.9. TiO2 yield in the slag was 89.6-94.1%. Hot metal contains, %: 5,51 C; 0.36 Ti; 0.35 Mn; 0.04 Si; 0,23 V. Vanadium yield in iron was 53.0%.

Effects of mixing technique, molar ratio, and filtration methods on the production of titanium power from secondary titanium slag though magnesiothermic reduction

Magnesiothermic Reduction from Titanium Dioxide to Produce Titanium Powder

Technological Study of Titanium Slag Production from Titanium-Bearing Blast Furnace Slag

Effects of Embedding Direct Reduction Followed by Magnetic Separation on Recovering Titanium and Iron of Beach Titanomagnetite Concentrate

Selective enrichment and extraction of well-catalyzed perovskites on melting-microwave heating process from blast furnace slag

Synergistic Leaching of Titanium, Aluminum, and Magnesium Components during Dilute Acid Pressure Treatment of High-Titanium Blast Furnace Slag

Simultaneous recycling of Si and Ti from diamond wire saw silicon powder and Ti-bearing blast furnace slag via reduction smelting: An investigation of the effects of refractories on recycling

Mechanism of Melt Separation in Preparation of Low-Oxygen High Titanium Ferroalloy Prepared by Multistage and Deep Reduction

Electrosynthesis of Titanium from High-Titanium Slag with Short-Process in Molten CaCl2

Recovery of Titanium from Red Mud Using Carbothermic Reduction and High Pressure Leaching of the Slag in an Autoclave

High-Titanium Slag Preparation Process by Carbothermic Reduction of Ilmenite and Wet-Magnetic Separation

Effect of Titanium Dioxide on Aggregation of Reduced Metallic Iron in Molten Slag

Influence of MgO on Mineral Structure and Metallurgical Properties of Blast Furnace Slag with Medium Titanium

A novel chemical pathway for energy efficient production of Ti metal from upgraded titanium slag

Study on Mechanism of Titanium Slag Smelting in DC electric Arc Furnace

Extraction of vanadium and enrichment of titanium from modified Ti-bearing blast furnace slag

Improving the production efficiency of high-titania slag in Ti extraction process: fluxing effect on formation of pseudobrookite

Complex Processing of a Titanium Magnetite Concentrate with Receiving the Products Containing Iron, The Titan and Vanadium

A novel process for preparation of titanium dioxide from Ti-bearing electric furnace slag: NH4HF2-HF leaching and hydrolyzing process

Effect of Basicity and MgO/Al2O3 Ratio on Viscosity and Crystallization Behavior of HIsmelt Titanium‐Containing Slag

Effect of titanium on the sticking of pellets based on hydrogen metallurgy shaft furnace: Behavior analysis and mechanism evolution