Abstract:The paper studies the piezoelectric output performance of a piezoelectric harvester with four piezoceramic layers, assessing if the piezoelectric material can be reduced. The shape optimization regards cantilevers with trapezoidal or triangular longitudinal sections, maintaining comparable electric response with the original rectangular structure. The piezoelectric material is subjected to maximum mechanical stress in the fixed constrained area, decreasing gradually down to null stress towards the free tip. It is worthwhile to study if the material reduction would result in an increased effectiveness in terms of voltage output per unit volume of piezoelectric material. The simulations conducted in COMSOL Multiphysics employ Structural Mechanics - Piezoelectric Devices module, in a Multiphysics approach through Piezoelectric Effect, coupling Solid Mechanics with Electrostatics. It was found that the electric response increases per unit volume of piezoelectric material in triangular configuration with material reduction. A comparable voltage output is obtained after reducing the amount of piezoceramic material towards the free tip, while using an inertial mass of the same value. Hence, the piezoelectric material is used more effectively in the case of triangular cantilever with material cutdown than the traditional rectangular shaped cantilever. The paper also addresses shape optimization while maintaining the same mechanical stress, studying the response when increasing the tip mass for the purpose. All the structures render an even more significantly increased power output for matching optimum load resistor.

Optimal position and dimensions of embedded normal piezoelectric transducers, higher order plate models and experimental approach

Mathematical Modelling of One-Dimensional Piezoelectric Transducers Based on Monoclinic Crystals

Optimal Distribution Of Actuator/Sensor In Piezothermoelectric Intelligent Structure

Piezothermoelasticity and Precision Control of Piezoelectric Systems: Theory and Finite Element Analysis

Actuator Placement Optimization For Piezothermoelectric Biotic Thermal Robust Structure

Parametric Analysis and Optimization of Radially Layered Cylindrical Piezoceramic/Epoxy Composite Transducers

Precision Placement Analysis of a New Multi-DOF Piezoelectric End-Effector via Finite Elements

Design Optimization of Piezocomposites Using a Homogenization Model: From Analytical Model to Experimentation

Diagonal Piezoelectric Sensors on Cylindrical Shells

Piezothermoelastic Characteristics and Control of Active Piezoelectric Structures

Distributed piezoelectric sensor/actuator design for dynamic measurement/control of distributed parameter systems: A piezoelectric finite element approach

Research on Effective Electric-Mechanical Coupling Coefficient of Sandwich Type Piezoelectric Ultrasonic Transducer Using Bending Vibration Mode

Optimization of cantilever piezoelectric harvester to triangular shape with material reduction using finite element analysis

An approximated 3-D model of cylinder-shaped piezoceramic elements for transducer design

Directivity and Excitability of Ultrasonic Shear Waves Using Piezoceramic Transducers—Numerical Modeling and Experimental Investigations

Damage assessment of smart polymer-matrix sandwich composite using multi-physics responses of in-situ piezoelectric transducers

Topology optimization of flexoelectric metamaterials with apparent piezoelectricity

Theoretical modeling of a circular piezoelectric actuator for micro-systems

A Three-Dimensional Piezoelectric Nanopositioner Using a Sandwich Transducer

Analysis of surface effect and flexoelectric effect on the electromechanical responses of bilayered transversely isotropic rectangular micro-plate

Topology optimization of piezoelectric sensor and actuator layers for active vibration control