Abstract:Volatile organic compounds (VOCs) are one of the major components of air pollution. Catalytic combustion is a promising technology for the treatment of VOCs and at its center is the preparation of efficient and cheap catalysts. In this study, by loading copper (Cu) and manganese (Mn) on Santa Barbara Amorphous-15 (SBA-15) molecular sieve, the Cu x –Mn y /SBA-15 ( x = 1, 2; y = 1, 2) composite metal oxide catalyst was prepared using the equal volume impregnation method. Their performance in the toluene catalytic combustion reaction was investigated by adjusting the molar ratio ( x : y ), and the loading of Cu and Mn. The results of the Brunner–Emmett–Teller (BET), X-ray diffraction (XRD), scanning electron microscopy (SEM), and X-ray photoelectron spectroscopy (XPS) analyses show that the CuMnO spinel phase can be detected in the Cu–Mn composite metal oxide catalyst doped with a low concentration of Cu. The overall rod-like structure of the fibrous network structure provides a large specific surface area, and the particle crystallinity is low and the dispersion is good. Due to the synergistic effect of Cu and Mn, the greater the amount of Mn 3+ and adsorbed oxygen species (O ads ) that are available, and the higher the turnover frequency (TOF) value, the better and more superior catalytic performance and excellent stability is obtained, when compared with the single-component oxides used in toluene catalytic combustion. After a continuous catalytic reaction for 12 h, the toluene conversion rate remained above 95%. The coupling effect of the catalytic reaction temperature and concentration of oxygen on the catalytic combustion of toluene was also studied. At a low reaction temperature (<250 °C), the increase of the concentration of oxygen played a superior role in promoting the conversion of toluene. The kinetic analysis of the toluene catalytic combustion process showed that the catalytic combustion of toluene by Cu–Mn/SBA-15 followed both the Mars–Van Krevelen (MVK) and Langmuir–Hinshelwood (L–H) reaction mechanisms. With the increase of the O ads amount caused by the decrease of the Cu ratio, the proportion of the L–H reaction mechanism increases.

Low-Temperature Catalytic Oxidation of Volatile Organic Compounds (VOCs) using Transition Metal Mixed Oxide Catalysts

Enhanced catalytic oxidation of toluene over manganese-based multi-metal oxides synthesized by ozone driving redox reaction

In Situ Fabrication of Highly Active Γ-Mno2/smmno3 Catalyst for Deep Catalytic Oxidation of Gaseous Benzene, Ethylbenzene, Toluene, and O-Xylene.

Catalytic Combustion of VOCs on Pt/CuMnCe and Pt/CeY Honeycomb Monolithic Catalysts

Low-energy production of a monolithic catalyst with MnCu-synergetic enhancement for catalytic oxidation of volatile organic compounds

Synergistic effects in Mn-Co mixed oxide supported on cordierite honeycomb for catalytic deep oxidation of VOCs

Transition Metal (fe2o3, Co3O4 and NiO)-Promoted CuO-Based Α-Mno2 Nanowire Catalysts for Low-Temperature CO Oxidation

Enhanced efficiency MnO2-Promoted pt catalyst for VOCs oxidation

Oxygen Vacancies Promote the Activation of O2 in Transition Metal Oxide Doped Ε-Mno2 for Low-Temperature CO Oxidation

Low-Temperature Combustion of Toluene over Cu-Doped SmMn<sub>2</sub>O<sub>5</sub> Mullite Catalysts via Creating Highly Active Cu<SUP>2+</SUP>-O-Mn<SUP>4+</SUP> Sites

Nanoporous CeO2-Decorated Cu-SmMn2O5 Composite Mullite Oxide Catalyst for Toluene Oxidation

Redox-Induced In Situ Growth of MnO2 with Rich Oxygen Vacancies over Monolithic Copper Foam for Boosting Toluene Combustion

Nanoporous CeO 2 -Decorated Cu-SmMn 2 O 5 Composite Mullite Oxide Catalyst for Toluene Oxidation

Preparation of MnO2 decorated Co3Fe1O powder/monolithic catalyst with improved catalytic activity for toluene oxidation

Revealing oxygen transfer between Mn3O4 and CuMn2O4 and its effect on enhanced catalytic oxidization of VOCs

Metal organic framework template method for the preparation of bimetallic oxide Cu n CoO x catalysts for the catalytic oxidation of volatile organic compounds

Catalytic oxidation of toluene, ethyl acetate and chlorobenzene over Ag/MnO2-cordierite molded catalyst

Coupling effect of reaction conditions on the catalytic activity of Cu–Mn composite oxide catalysts for toluene

Insight into the catalytic performance and reaction routes for toluene total oxidation over facilely prepared Mn-Cu bimetallic oxide catalysts

In Situ Fabrication of Highly Dispersed Co-Fe-Doped-δ-MnO2 Catalyst by a Facile Redox-Driving MOFs-Derived Method for Low-Temperature Oxidation of Toluene.

Influences of different surface oxygen species on oxidation of toluene and/or benzene and their reaction pathways over Cu-Mn metal oxides