Abstract:Abstract Liquid crystal thermography and infrared thermography techniques are typically employed to measure detailed surface temperatures, where local heat transfer coefficient (HTC) values are calculated by employing suitable conduction models. One such practice, which is very popular and easy to use, is the transient liquid crystal thermography using one-dimensional semi-infinite conduction model. In these experiments, a test surface with low thermal conductivity and low thermal diffusivity (e.g. acrylic) is used where a step-change in coolant air temperature is induced and surface temperature response is recorded. An error minimization routine is then employed to guess heat transfer coefficients of each pixel, where wall temperature evolution is known through an analytical expression. The assumption that heat flow in the solid is essentially in one-dimension, often leads to errors in HTC determination and this error depends on true HTC, wall temperature evolution and HTC gradient. A representative case of array jet impingement under maximum crossflow condition has been considered here. This heat transfer enhancement concept is widely used in gas turbine leading edge and electronics cooling. Jet impingement is a popular cooling technique which results in high convective heat rates and has steep gradients in heat transfer coefficient distribution. In this paper, we have presented a procedure for solution of three-dimensional transient conduction equation using alternating direction implicit method and an error minimization routine to find accurate heat transfer coefficients at relatively lower computational cost. The HTC results obtained using 1D semi-infinite conduction model and 3D conduction model were compared and it was found that the heat transfer coefficient obtained using the 3D model was consistently higher than the conventional 1D model by 3–16%. Significant deviations, as high as 8–20% in local heat transfer at the stagnation points of the jets were observed between h1D and h3D.

Two‐dimensional finite element inverse heat transfer approach with conjugate gradient method to evaluate the energy requirement of bread under various conditions

Estimation of the energy requirement of bread during baking by inverse heat transfer method

A numerical method for two-dimensional nonlinear transient inverse heat conduction problems for orthotropic material

A Computational Method to Solve for the Heat Conduction Temperature Field Based on Data-Driven Approach

Estimation of Surface Temperature and Heat Flux over a Hollow Cylinder and Slab using an Inverse Heat Conduction Approach

Hybrid approach for solution of inverse heat conduction problems

INVERSE HEAT CONDUCTION PROBLEM OF DEDUCING INNER WALL TEMPERATURE BY USING CONJUGATE GRADIENT METHOD

Interactive Influence of Conduction–Convection–Radiation on Heat Transfer from a Discretely and Non-Identically Heated Electronic Gadget

Inverse Heat Conduction Problem for Estimating Heat Flux on A Triangular Wall

Three-Dimensional Transient Heat Conduction Equation Solution for Accurate Determination of Heat Transfer Coefficient

Inverse and efficiency of heat transfer convex fin with multiple nonlinearities

A Robust and Fast Algorithm for Three-Dimensional Transient Inverse Heat Conduction Problems

Inverse Determination of Boundary Conditions and Sources in Steady Heat Conduction With Heat Generation

A Generalized Benders Decomposition-Based Algorithm for Heat Conduction Optimization and Inverse Design

Iterative Solutions for the Nonlinear Heat Transfer Equation of a Convective-Radiative Annular Fin with Power Law Temperature-Dependent Thermal Properties

Solving of Two-Dimensional Unsteady-State Heat-Transfer Inverse Problem Using Finite Difference Method and Model Prediction Control Method

A general numerical method for solving the three-dimensional hyperbolic heat conduction equation on unstructured grids

Three-Dimensional Transient Heat Conduction Equation Solution for Accurate Quantification of Heat Transfer Coefficient in Transient Liquid Crystal Experiments

Optimization of the One-Dimensional Transient Heat Conduction Problems Using Extended Entransy Analyses

New graphical user interface for an application to assist solution analysis with optimization of the 1D inverse heat conduction problem

A Gradient-Based Strategy to Construct Efficient Heat Conduction Path for Arbitrary Configurations