Abstract:Journal of Composite Materials, Ahead of Print. During the last decades, environmental concerns and limited resources have set focus of research on lightweight, mechanically high-performing structures for the transportation industry, in order to reduce fuel consumptions and CO2 emissions. Friction Stir Joining (FSJ), as a variant of the Friction Stir Welding (FSW), is an innovative friction-based joining technique for metal-composite hybrid structures. Joining in the plasticized state below the melting temperature of the metal leads to a comparatively small heat-affected zone, so that only minor metallurgical changes occur. Additionally, only a short processing time and no additional weight in form of fasteners is needed. The main objective of this study is to evaluate the feasibility of metal-composite structures via FSJ, intending to enable a macro-mechanical interlocking bonding mechanism. Main focus was given to the integration of an aluminium nub inserted in a carbon fiber-reinforced polyphenylene sulfide (CF-PPS) sheet, to ensure sufficient plasticization of the aluminium part and no degradation in the polymer part. Residual stress arising from the friction stir joining process was also characterised using the Contour method. In this study, aluminium alloy 6082-T6 and CF-PPS composite sheets were used to produce long lap joints. Results have shown that the joints were created at almost constant peak temperature slightly above the melting temperature of the PPS but no physical-chemical changes were detected in the PPS. In addition, the influence of a PPS film as interlayer between the sheets was investigated in order to explore a method for preventing galvanic corrosion. Preliminary results indicate that it is not possible to integrate a metal nub to the CF-PPS without interrupting the PPS film. However, it is possible to create a nub within the PPS film.

Research on Joint Strength and Mechanism of Composite/Aluminum Alloy Connections Based on FDS Technology

Mechanical Properties and Failure Behavior of Flow-Drilling Screw-Bonding Joining of Dissimilar Aluminum Alloys under Dynamic Tensile and Fatigue Loading

The effect of staged process parameters for flow drill screws on the strength of the connection between carbon fiber-reinforced plastic and aluminum alloy

Research on joint strength and energy absorption of CFRP and Al sheets bonded-FDS hybrid joining

Shared mechanism between flow drill screw and friction stir welding and its impact on failure prediction of steel-aluminum joints

Advances in joining technology of carbon fiber-reinforced thermoplastic composite materials and aluminum alloys

Flow drill screw (FDS) technique: A state-of-the-art review

Design and Performance Study of Carbon Fiber-Reinforced Polymer Connection Structures with Surface Treatment on Aluminum Alloy (6061)

Feasibility study of friction stir joining of aluminium with carbon fibre reinforced thermoplastic composite

Forming quality and microstructure evolution of AA6061‐T6 aluminum alloy joint during flow drill screwing process

New technique of friction-based filling stacking joining for metal and polymer

Evaluation of Joint Strength for CFRPs and Aluminum Alloys by Friction Stir Spot Welding Using Multi-Stage Heating

Rapid multi-material joining via flow drill screw process: experiment and FE analysis using the coupled Eulerian‒Lagrangian method

Achieving high strength friction lap spot joints of carbon fiber reinforced thermosetting composite to aluminum alloy with additional thermoplastic interlayer

Mechanical Testing of Flow Drill Screw Joints Between Fibre-Reinforced Plastics and Metals

Characterization of Flow Drill Screwdriving Process Parameters on Joint Quality

Modeling and simulation of the flow drill screw process of a DP590/Al6061-T6 multi-material joint used for vehicle body

Microstructure and mechanical properties of 6061-T6 aluminum alloy and Q235 steel via probeless friction stir extrusion joining

Experimental analysis of the flow drill screw driving process

Friction self-riveting welding between polymer matrix composites and metals

Optimization of Friction Lap Joining Parameters and Exploration Connection Mechanism of CFRPA6/6061-T6 Aluminum Alloy Hybrid Structures