A Wideband Phased Array With Broad Scanning Range and Wide-Angle Impedance Matching

Fu-Long Jin,Xiao Ding,You-Feng Cheng,Bing-Zhong Wang,Wei Shao
DOI: https://doi.org/10.1109/tap.2020.2982509
IF: 5.7
2020-08-01
IEEE Transactions on Antennas and Propagation
Abstract:For wide-angle scanning phased arrays, the efficiency of active elements is deteriorated with the increase of mutual impedance. This article demonstrates an effective strategy to control the mutual impedance among array elements by canceling the major coupling effect. The implemented wide-angle impedance matching (WAIM) of a wideband phased array verifies the validity of the proposed strategy. For the array element, to obtain wide-angle radiation and wideband characteristic, parallel slots with unequal lengths are deliberately etched on a low-profile substrate integrated cavity (SIC). The mutual impedance between two arbitrary elements is remarkably controlled and compensated by canceling the major coupling effect, which is realized by etching symmetrical slots and loading periodical loops within each element. With the controlled mutual impedance, the proposed array possesses excellent wide-angle scanning performance. Both the simulated and measured results indicate that the designed array steers its main beam from −70° to +70° in the xoz azimuth plane in a broad frequency range from 8.0 to 9.5 GHz. The active $S$ -parameter of each element remains lower than −10 dB in the operating band while the array scans. Due to the implemented WAIM, the total efficiency of the array exceeds 90% during the scan and the fluctuation of realized gain is less than 3 dB.
telecommunications,engineering, electrical & electronic
What problem does this paper attempt to address?
The paper attempts to address the issues in wide-angle scanning phased array antennas caused by mutual coupling effects between elements, which lead to reduced radiation efficiency, radiation pattern distortion, and changes in input impedance. Specifically, the paper proposes an effective strategy to control the mutual coupling effects between array elements, achieving Wide-Angle Impedance Matching (WAIM) by eliminating the main coupling effects, thereby improving the performance of the array during wide-angle scanning. ### Main Issues: 1. **Impact of Mutual Coupling Effects on Wide-Angle Scanning Phased Arrays**: - Reduced radiation efficiency - Radiation pattern distortion - Changes in input impedance - Scanning blind spots and gain instability 2. **Limitations of Existing Solutions**: - Increasing element spacing or orthogonal arrangement of array elements can alleviate mutual coupling effects but lead to grating lobes and reduced cross-polarization ratio. - Existing decoupling techniques (such as broadband WAIM layers, enhanced bandwidth decoupling networks, and surface wave blocking walls) are effective but structurally complex and bulky. ### Proposed Solution in the Paper: - **Design of Low-Profile Planar Phased Array**: - Using multiple parallel slots of different lengths etched on a low-profile Substrate Integrated Cavity (SIC) to achieve wideband characteristics. - Introducing symmetrical slots and periodic loading rings to significantly control mutual coupling effects by eliminating far-field and surface wave coupling. - Achieving Wide-Angle Impedance Matching (WAIM) to maintain good scanning performance over a wide angle range. ### Experimental Validation: - **Simulation and Measurement Results**: - The designed array can scan the main beam in the xoz plane from -70° to +70° within the frequency range of 8.0 GHz to 9.5 GHz. - The active S-parameters of each element remain below -10 dB across the entire operating bandwidth. - The total efficiency of the array exceeds 90%, with gain fluctuation less than 3 dB. Through these designs and experimental validations, the paper demonstrates the effectiveness of the proposed strategy in improving the performance of wide-angle scanning phased arrays.